Water heating Filling Gas Insulating Glass Production Line

LJBZ2535 filling gas ,Abundant quality assurance of materials for aerated glass production line​

• The washing machine uses six soft (Low-e) brushes with the 01mm diameter only.

• It has 6 brushes which are all soft brush, can wash low-e glass, flat glass, tempered glass and so on. It has a diameter of less than 0.1mm bristles, never damage glass, especially for low-e glass.

   

   

• Using Europe's advanced anti-noise system to create a good working environment for employees

• The noise can be controlled below 90 decibels by using nylon gear and sponges.

   

   

• Water heating system and water filter system

• As different countries have different water quality, in order to ensure that the glass is washes clearly enough, adopting air heating system, to use soft water to wash glass. What’s more, using water filter system to make water recycling, save water and keep the water clear.

   

•     

• The special structure inside the washing machine can automatically recognize glass thickness. Allowing different thicknesses of glass to be transferred quickly, increasing production speed. According to the test, it takes only 22s to produce a 1m*m insulating glass.

   

  1). There is a universal joint device, when the glass thickness was changed, the wind knife will move forward and backward to adjust the distance so that the relative distance between the wind knife and the glass is constant, so as to avoid damage to the glass due to the changes of the glass thickness.

• There are chain gears on both sides of the bottom of the glass to actively transfer the glass which can keep a fast speed, not only the large size, small size glass can also be passed quickly.

•  

• 

• 

                                  

   

• There is the Low-e glass sensor in the washing machine

•  

  Shaped, the first piece of glass automatically stop at the end of the aluminum frame assembly period, artificial put aluminum frame, the second piece of glass at the same time automatic stop at the end of the cleaning discharging period, artificial glass moved close to aluminum frame assembly, after the piece, stepping on foot switch, or better ones for pressing the glass into the close to the specified size.

   

   

  NAME	ORIGIN	BRAND
  Transfer motor	Germany	SIEMENS
  Brush motor	Germany	SIEMENS
  Servo motor	Germany	SIEMENS
  PLC	Germany	SIEMENS
  Low voltage electrical appliance	Germany	SIEMENS
  Frequency converter	Germany	SIEMENS
  Micro Switch	Taiwan	TEND
  Button and indicator light	France	SCHNEIDER
  touch screen	Taiwan	WEINVIEW
  Intermediate relay	Japan	OMRON
  Water pump	China	LINGXIAO
  Guide	Taiwan	HIWIN
  Pneumatic Components	Taiwan	AIRTAC
  electric gauge	China	MIRAN
  Photoelectric switch	Korea	AUTONICS
  JINAN LIJIANG AUTOMATION EQUIPMENT CO.,LTD

  

  If the size of the production, first set the distance between X and Y on the touch screen, manual test whether the distance is correct. Clean first: small pieces, directly into the flat pressing section, while large pieces of glass in the aluminum frame assembly section put the aluminum frame, after the completion of the foot switch, glass into the flat pressing section for the flat pressing.

  Take the glass:Click "Pick glass" in the automatic state, and the board will close, put down the glass, open the board, and send the glass out of the board. (in the automatic production, the first piece of glass has been sucked on the movable plate, and there is no subsequent glass, so the first piece of glass needs to be taken out, using this function)