Active Member
|
[China]
Address: 2F, Building 8, YuanLing Industrial Park, ShangWu Community, ShiYan Street, Bao'an District, Shenzhen，China
Contact name:Sandy Wang
Shenzhen DeKang Electronic Cleaning Appliances Co.,LTD |
|
|
Mechanical ultrasonic cleaners are suitable to clean irregular and
complex specialized instruments,components and PCBs of sundry
shops, workshops, factories, etc; smash, emulsify, scatter,
hydrolyze, extract, degas certain analyzed stuffs in labs.
Ultrasonic cleaning is a technology that uses high frequency sound
waves (ultrasonic: above the range of human hearing) to agitate an
aqueous or organic medium (cleaning chemistry) that in turn acts on
contaminants adhering to substrates like metals, plastics, glass,
rubber and ceramics.
. Die casting stainless steel tank
. Industrial grade integrated circuit
. 20-80ºC temperature range
. 0-20 minutes working time
. Deawaxing and degreasing function
. 28KHz for gross rinse or 40KHz for intensive rinse
| Model: | DK-3000H |
| Tank Size(mm): | 500*300*200mm |
| Overall Size(mm): | 550*330*380mm |
| Capacity: | 30L |
| Frequency(KHz): | 28/40 KHz |
| Ultrasonic Power(W): | 0~600W |
| Heating Power(W): | 500W |
| Timing Range (min:secs): | 0-20/Always On |
| Temperature Range(ºC): | 20-80ºC |
| Water Drainage: | Yes |
Certification:
All Dekang’s standard products have achieved most international standards, such as CE certification, RoHS certification, FCC certification etc. Besides, all no-standard products also can satisfy all requirements of these most international standards.
Medical and surgical instruments in a variety of sizes and
complexity can pose challenges when it comes to cleaning,
disinfecting and sterilizing them after use. An ultrasonic cleaner
is an ideal tool for the first step in this three step process to
protect medical personnel and patients from possible infection due
to pathogens that remain on the instruments after a procedure.
Suggested Ultrasonic Cleaning Procedure
In all cases manufacturers’ instructions should be followed when using an ultrasonic cleaning process. These are representative steps.
Fill the ultrasonic cleaning tank with an approved medical instrument cleaning solution such as CLN-LR012 available from Tovatech following dilution instructions provided. Turn the cleaner on to start the degassing process. This step removes entrained air in new solutions that interferes with the efficiency of cavitation and takes approximately 10 minutes.
In the meantime:
At the end of the cycle, remove the instruments from the ultrasonic cleaning bath and thoroughly rinse them to remove all traces of the cleaning solution. Deionized water rinses will avoid spotting. If the instruments are not to be immediately disinfected and sterilized be certain that they are thoroughly dried and protected. Part reassembly can occur after sterilization.
Procedures should be in place to guide the replacement of used ultrasonic cleaning solutions. In some instances it is recommended that solution be drained and tanks thoroughly cleaned and dried after each ultrasonic cleaning cycle. Most solutions available today are biodegradable, which facilitates disposal but local authorities should be consulted on proper practices.
