Zhejiang THOR Electric Co., Ltd |
|
Net work Signal surge protective device Ethernet Cable RJ45 Port Surge Protector
Model: TRSS-RJ11 / 45
Color: white
Authentication: CE ECM
Brief introduction
The TRSS-RJ45/8 type network lightning arrester is a lightning
protection measure taken by Zhejiang tohr Electric Co., Ltd. to
independently develop and manufacture the network system.
It's an overvoltage protector designed for ETHERNET network. It can
be used for servers, workstations, HUB and other RJ45 interfaces.
For example, the input / output terminal of EPRJ45-5/100M is RJ45
interface, and its transmission signal rate can reach 100Mbps or
1000Mbps. It is mainly used for lightning protection measures
against network system. To prevent high voltage from causing short
circuit and combustion and explosion is the important manifestation
of internal lightning protection.
Working principle of product
The lightning arrester not only can protect the high
voltage of the atmosphere, but also can be used to protect the
operation of high voltage. If there is a thunderstorm, a high
voltage will appear and the electric equipment may be dangerous. At
this point, the arrester will play a role to protect the power
equipment from damage. The most important function of the arrester
is to limit the overvoltage to protect the electrical equipment.
Lightning arrester is a device to make the lightning current flow
into the earth, so that the electrical equipment does not generate
high voltage.
Product features
1. excellent performance, small insertion loss, high
transmission frequency and low attenuation coefficient, to ensure
that the lightning arrester does not affect the system performance.
2. traffic flow to further improve safety
3. is easy to install and easy to install
4. protection voltage exceeds self protection,
automatic disconnection and recovery.
Product specification
|
Use of attention
1. installation, it can work steadily for a long time. If it is
found that the transmission performance of the system is reduced or
the signal is interrupted due to the cause of surge protection, it
should be maintained or replaced in time.
2. line should strive to be short, thick and straight,
so as to reduce the influence of distributed inductance on the
ability of lightning electromagnetic pulse.
3. lightning protector's input port (IN) is connected
to the signal channel, and the output terminal (OUT) is connected
with the input end of the protected device, so it cannot be
connected to the reverse side.
4. lightning protection device IN as input and OUT as
output, the input end is connected with the outside, and the output
end of the input end of the connecting device is protected.
Company profile
Zhejiang Thor Electric Co., Ltd is committed to meeting the
requirements of the European Union’s Waste Electrical and
Electronic Equipment (WEEE) directive. This directive requires
producers of electrical and electronic equipment to finance the
take-back for re-use or recycling of their products placed on the
EU market after 2005.