RJ45 10GBE SFP+ Copper Optical Transceiver Module Cisco Compliant

30-meter 10G based industrial Copper Transceiver

Feature

• Up to 10Gb/s bi-directional data links
• Hot-pluggable SFP footprint
• Extended case temperature range (-40°C to +85°C )
• Fully metallic enclosure for low EMI
• Low power dissipation
• Compact RJ-45 connector assembly
• Detailed product information in EEPROM
• +3.3V single power supply
• Access to physical layer IC via 2-wire serial bus
• Compliant with SFP MSA
• Compliant with IEEE Std 802.3TM-2002
• Compliant with FCC 47 CFR Part 15, Class B
• RoHS Compliant Products

Specification

Application

• 10 Gigabit Ethernet over Cat 5 cable
• Switch/Router to Switch/Router Link
• High speed I/O for file severs

Description

1. This copper SFP transceiver is high performance, cost effective module compliant with the 10 Gigabit Ethernet supporting 10Gb/s full duplex data-links with 5-level Pulse Amplitude Modula-tion (PAM) signals.
2. All four pairs in the cable are used with symbol rate at 250Mbps on each pair.
3. It provides standard serial ID information compliant with SFP MSA, which can be accessed with address of A0h via the 2-wire serial CMOS EEPROM protocol.
4. The physical IC can also be accessed via 2-wire serial bus at address ACh.

Dimension

Production steps

• Welding: Weld the necessary components
• Cleaning: To avoid any possible dysfunction due to dust or scraps on the PCB boards.
• Assembling: Builds up components of a product, like panels, screws, PCB boards.
• Testing: To make sure the product is basically working fine after assembling
• Aging: To check if the product can work smoothly for long time without any minors such as LED indicators, voltage. This will usually last for 24 to 48 hours.
• Testing: To test if the product can process data or video signals correctly. Any data loss? Transmission rate correct? Any data packet failure? Such questions would be verified in this procedure.
• QC testing: This is the third and also last check of product quality. If it goes good, our packing staff will pack it up according to customer requirements and attach to the packing box a product label.
• When all above is done, the product will go to market.