Combined Line Type Wide Use Armoured Copper Cable Recycling Machine

Combined Line Type Wide Use Armoured Copper Cable Recycling Machine

TF-800 copper cable recycling plant are complete processing line for copper wire recycling which is applicable for large size factory. It includes first crusher, second shredder,separator and dust collector. It can deal with larger size scrap cooper cables with higher efficiency.

Scrap copper wire cable granulator Advantages :
1.The cable recycling plant adopts dry separation equipped with dust collecting system.So the working area will be clean and there will be no pollution surrounding environment.
2.The whole process is controlled by PLC control box with one press on the button it will start or work.Very easy to operate.
3.Easy commissioning.For processing wires in different diameter, just change the screen size and adjust the force of blower and height of baffle in the vibrator.

Copper Cable Recycling Machine Specifications: 

Waste copper wire recycling line Components and Working principle :
First crusher -- conveyor -- Second Shredder and Electrical Control Cabinet -- Separator and Dust Collector

1. The first crusher of the recycling plant crushes the wires/cables into 10—20mm length.
2. By conveyor, crushed wires/cables are conveyed to the second crusher, which crush them again into 3-5mm length plastic pieces and copper granules.
3. The mixture is sent to the vibration system. By airflow and vibration, plastic pieces are separated from copper granules thoroughly.
4. Copper granules and plastic pieces come out of the granulator from different outlet. Dust is collected by dust collector through air duct.

Waste copper wire recycling line Working procedure:
1. Put wires and cables into the crusher, in which they are crushed and plastic sheath and copper separated completely. The length of the crushed material is based on the mesh of the riddle: the bigger the mesh is the longer the crushed material will be and the larger the output will be. The mesh should be chosen in production according to the type of the material.
2. The crushed material (mixture of copper granules and plastic pieces) is conveyed to the separator by the conveyor, during which procedure dust and part of plastic pieces of light weight(including fiber, rope, or tapes, etc. mixed in the wires) are collected by the pressure-reducing blower. The above opening of the pressure reducing blower is connected with the dust collector opening in which a dust collecting bag is used to prevent discharge of dust for the purpose of environmental protection. Dust and part of plastic pieces of light weight are collected in this bag and will be discharged when the bag is full.
3. The separator is used for separating plastic pieces and copper granules. According to the differences of the physical properties and specific gravity between different materials, there is specific gravity deviation under the forces of Aerodynamic and Vibration friction. By adjusting the speed of material conveying and amplitude parameters, copper granules (of larger specific gravity) will move to the riddle bottom and move from down to up, and plastic pieces (of smaller specific gravity) will move to the above of copper granules and move from up to down, and in the end they will both be discharged through different openings.
4. All the units are installed on the underbed to form a whole structure. The machine is adjusted ready for production before shipping, and the customer only need to connect it to the power supply.