300kg Electric Power Waste Copper Wire Granulator Copper Wire Recycling Machine

300kg Electric Power Waste Copper Wire Granulator Copper Wire Recycling Machine

TF series Cable wire recycling machine process the waste electric wire and cable into copper and plastic granule. Copper is separated from the plastic, separation efficiency can be 99%. For the copper granule, it can be sold directly or go to further refining. Through our copper electrolysis machine, the copper can be refined into cathode copper in above 99.99% purity. The plastic granules normally are PVC or rubber material, it can also be sold directly.

Copper wire recycling machine advantages:
1. Integrated structure, small dimensions, easy to move, saving space.
2. Low power consumption, stable performance.
3. Minimum copper recycling rate can reach 99%.
4. No water is needed, no dust, no environmental pollution.
5. Controlled by electricity control panel, highly automatic.

Scrap Copper Granulator Application:
The Household and Industrial Copper Wire Recycling Machine is dry type structure, mainly used to all kinds of waste copper wire, the copper wire will be separated into tiny copper rice and PVC. This machine can recycle the copper wire which diameter is 0.3mm-20mm. Automobile electrical wire or the electric wire of car, motorcycle electric wire, computer case wire and communication cable, etc

Electric Copper Wire Recycle Machine Specifications: 

Automatic Recycling Machine Working principle:
For the small capacity, the cable wire raw material can be put into the all-in-one machine directly, after crushing, then the air separator will make the copper and plastic suspended on the screen. Then the Copper will be separated from the plastic by weighting method and the friction force which produced by the Surface of the mesh.

1.Put wires and cables into the crusher, in which they are crushed and plastic sheath and copper separated completely. The length of the crushed material is based on the mesh of the riddle: the bigger the mesh is the longer the crushed material will be and the larger the output will be. The mesh should be chosen in production according to the type of the material.
2.The crushed material (mixture of copper granules and plastic pieces) is conveyed to the separator by the conveyor, during which procedure dust and part of plastic pieces of light weight(including fiber, rope, or tapes, etc. mixed in the wires) are collected by the pressure-reducing blower. The above opening of the pressure reducing blower is connected with the dust collector opening in which a dust collecting bag is used to prevent discharge of dust for the purpose of environmental protection. Dust and part of plastic pieces of light weight are collected in this bag and will be discharged when the bag is full.
3.The separator is used for separating plastic pieces and copper granules. According to the differences of the physical properties and specific gravity between different materials, there is specific gravity deviation under the forces of Aerodynamic and Vibration friction. By adjusting the speed of material conveying and amplitude parameters, copper granules (of larger specific gravity) will move to the riddle bottom and move from down to up, and plastic pieces (of smaller specific gravity) will move to the above of copper granules and move from up to down, and in the end they will both be discharged through different openings.
4.All the units are installed on the underbed to form a whole structure. The machine is adjusted ready for production before shipping, and the customer only need to connect it to the power supply.