1500r / Min High Power Servo Motor Instantaneous Peak Torque For Chip Mounters SGMGV-13ADA6C

 

 

 

 

 

1Load Moment of Inertia
The larger the load moment of inertia, the worse the movement response of the load.
The allowable load moment of inertia (JL) depends on the motor capacity, as shown above. This value is provided
strictly as a guideline and results may vary depending on servomotor drive conditions.
Use the AC servo drive capacity selection program SigmaJunmaSize+ to check the operation conditions.
The program can be downloaded for free from our web site (http://www.e-mechatronics.com/).
An overvoltage alarm (A.400) is likely to occur during deceleration if the load moment of inertia exceeds the
allowable load moment of inertia. SERVOPACKs with a built-in regenerative resistor may generate a regenerative
overload alarm (A.320). Take one of the following steps if this occurs.
x Reduce the torque limit.
x Reduce the deceleration rate.
x Reduce the maximum speed.
x Install an external regenerative resistor if the alarm cannot be cleared using the steps above. Refer to
Regenerative Resistors on page 351.

 

 

 

Servomotor Main Circuit Cables
Customers must assemble the servomotor’s main circuit cables and attach connectors to connect the
SERVOPACKs and the SGMGV servomotors.
The connectors specifi ed by Yaskawa are required. Note that the connectors vary depending on the operation
environment of servomotors.
Two types of connectors are available.
x Standard connectors