Active Member
|
[China]
Address: No.40 Ailing Road, Moling Street, Jiangning District, Nanjing
Contact name:James Zhang
Nanjing Saiko Controls Co.Ltd |
|
|
Introduction:
SK20 is used for floor heating system, including heating
cable and other heating elements. The setting range of
thermostat is 5~40℃. When the light is red ,it means the
thermostat works.You can set the temperature freely as you want.
Placement of thermostat:
Thermostat is to be mounted on the wall with free air
circulation around it . Furthermore it has to be placed where it is
not influenced by any other heating sources (e.g. the sun), draft
from
doors or windows, or by the temperature of an exterior wall.
Mounting of floor sensor:
Floor sensors should be placed in the installation pipeline buried on the floor, the end of the pipeline is thicker, and placed as high as possible in the concrete layer. Sensor cables can extend up to 50 meters, with separate cables F or power supply currents. Two conductors in a multi-conductor cable, such as those used to supply heating cables, may not be used. Voltage signals that may interfere with thermostat functions may occur. If the cable is used with the screen, the screen may not be connected to the ground, but it must be connected to terminal 7. The best installation is a separate cable for the sensor and then install it in a separate pipe.
Temperature and Value of floor sensor:
| Temperature(℃) | Value(Ω) |
| 5 | 22070 |
| 10 | 17960 |
| 20 | 12091 |
| 30 | 8312 |
| 40 | 5827 |
Dimensions:
Wiring diagram:
Operation manual:
Temperature Setting:
Thermostat has a scale range of +5/+40 . To assist the adjust-ment, the thermostat has a LED which will glow RED when the heating is ON. The thermostat should be set to maximum temperature setting until the desired temperature of the room or floor is achieved. The control knob should then be turned back until the LED goes out. Fine adjustments can be made over the next 1/2 days to suit individual requirements.
Thermostat Adjustment:
When the room temperature has been stabilized, the
thermostat set position may be adjusted to match actual room
temperature. Measure the temperature of the room with an accurate
thermometer. Remove control knob(1) and spin the pole(D),then
reposition the control knob so that the indicated temperature line
shows the same as the measured temperature. We have adjusted the
temperature, please do not
spin the pole when installation.
Parts:
FAQ:
1. I saw the same one from other suppliers, why yours are expensive?
Firstly, our thermostat has been sold for 6 years, the quality is highly promised. The material we use are imported PC fire-resistant material, which is the best one for thermostat.
Secondly, there exists a batch of same thermostats as ours, which are fake and inferior goods.The surface will turn yellow after using a time and have potential safity problems. So please pay attention when you make choice.
2. What if I don't like it when I get it?
We accept you send it back but you need pay the both ways freight and any cost during the way, like the tax.
3. Will this thermostat come with the sensor or I should buy separately?
All the thermostats will come with matched sensor. Also, we could offer only thermstat or only sensor if you need.
Feedback
We usually leave possitive feedbacks with Five Stars for every customer. To foster a healthy Ali community and encourage us for better improvement, we much appreciate if you could do the same to us!
More products for you to choose:
