|
[China]
Trade Verify
Address: No.210,211,212,213,214,Building 1,No.12 Industry Western Road,SongShanHu,Dongguan,Guangdong,China.523808
Contact name:Carina
Med Accessories Technology Dongguan Co., Ltd. |
|
Verified Suppliers
|
|
|
Adult/Pediatric dual tube GE-Marquette NIBP hose 2058203-002
Compatibility:
| Manufacturer | Model |
|---|---|
| Datex Ohmeda | Aespire 7900, E-PRESTN |
| Draeger | Narkomed 6400 |
| GE Healthcare > Corometrics | 120, 250 |
| GE Healthcare > Critikon > Dinamap | Carescape B650, Carescape B850, Carescape B450 |
| GE Healthcare > Marquette | Dash 2000, Dash 2500, Dash 3000, Dash 4000, Dash 5000, Eagle 3000, Tram 451, Dash, Eagle, Procare B40, SOLAR, Tram, Tram 400, Tram 450, Tram 800, Tram 850, Tram 851 |
To ensure proper use of the SpO2 sensor and its cable, please follow these guidelines:
Cleaning: Clean the sensor and cable before each patient use. Follow the recommended cleaning procedures provided by the manufacturer or refer to the product documentation.
Sensor Placement: Place the sensor on the index finger, making sure the finger is fully inserted and the tip of the finger rests against the finger stop inside the sensor. Alternatively, you can use small-sized thumb, middle and ring fingers, the little finger, or the big toe as alternate sites. Ensure that the fingernail is located under the finger stop on the SpO2 sensor clamp.
Avoid Interference: Do not place the sensor on the same arm as the blood pressure cuff, arterial catheter, or intravascular line. Remove all nail polish as it can affect accuracy. Avoid using the sensor inside or near an MRI, and keep intense light sources away from the sensor.
Changing Measurement Site: For long-term use, change the measurement site every 4 hours to maintain the integrity of the patient's skin.
Restless Patients: In the case of restless patients or excessive motion, consider using Med Accessories Soft tip, wrap, or multi-site sensor to help secure the sensor to the patient.
Equipment:
Connect the sensor cable to the appropriate equipment (pulse oximeter).
Turn on the equipment and ensure its correct operation by consulting the monitor's operation instructions.
To ensure proper operation of the monitor, periodically connect and disconnect the sensor cable from the monitor cable.
Systematically check the sensor and cable at least once a month (or more frequently depending on usage) for appearance, insulators, connector contact pins, and overall mechanical integrity.
Do not use or discard any sensor that shows mechanical or electrical flaws.
Operating Conditions:
Ambient temperature: 0°C to +40°C
Relative humidity: 0% to 80%
Atmospheric pressure: 860 to 1060 HPa
Cleaning, Disinfection, or Sterilization:
In departments where sterility levels need to be observed, follow the recommended cleaning, disinfection, or sterilization methods provided by Med Accessories or as specified in the product documentation.
It is essential to follow these guidelines to ensure accurate and safe measurements with the SpO2 sensor and its connecting cable. Consult the manufacturer's instructions and guidelines for specific cleaning and disinfection procedures, as they may vary depending on the product.
