Active Member
|
[China]
Address: ZHONGXING EAST ROAD 208, XIKOU TOWN315502, FENGHUA CITY, ZHEJIANG PROVINCE, CHINA
Contact name:Ricky
Ningbo Nijia Electronics Technology Co.,Ltd |
|
|
Goyen Aluminum pilot valve 3.2 mm 110 V AC 1/8 " RCA3D pulse jet valve
Suitable for
AII Goyen dust collector diaphragm valves.
Installation
1. Prepare pilot mounting hole in panel to
019.3/19.4 (0.760"). Panel thickness must
exceed 1 .5mm (0.062").
2. Ensure o-ring is in place before
tightening locknut. Preferably install pilot
valves with solenoid on top.
3. For reliable operation ensure supply voltage is
within -10% and +15% of rated solenoid voltage. Replace
components within 1 million cycles
(refer to Spare Parts)
Option:
| 1 | Waterproof enclosure with embedded screw terminal coil according to protection class IP67, CEE 10 |
| 2 | Explosionproof solenoids for hazardous locations according to “ATEX” (CENELEC) and national standards |
| 3 | Explosionproof and watertight solenoids according to “NEMA” standards |
| 4 | Hose connection executions (3" only) |
| 5 | Compliance with “UL” standards |
| 6 | Plug with visual indication and/or peak voltage suppression |
| 7 | Electronic timer |
| 8 | Valves can also be supplied with FPM (fluorelastomer) diaphragms and seals. Use the appropriate suffix letter for identification |
Construction:
| Body | Aluminium (diecast) |
| Ferrule | 304 SS |
| Armature | 430FR SS |
| Seals | Nitrile or Viton (reinforced) |
| Spring | 304 SS |
| Screws | 302 SS |
| Clip | Mild steel (plated) |
| Locknut | Mild steel zinc passivated |
| Voltage | DC: 24V, AC: 24V,48V,110V,230V |
| Working Temperature | - 20 to + 85 ℃ |
| Protection Class | IP65 |
| Coil Insulation Class | F |
| Working Pressure | 0.35-0.85Mpa |
Directions:
| 1 | For compression fitting types tightness is achieved by the compressed gasket on the blow tube |
| 2 | Other pipe threads are available on request |
| 3 | Installation/maintenance instructions are included with each valve |
| 4 | Spare parts kit and replacement coils are available |
| 5 | Prepare supply and blowtube pipes to suit valve specification. Avoid installing valves underneath the tank. |
| 6 | Ensure tank and pipes are free from dirt, rust or other particulate. |
| 7 | Ensure supply air is clean and dry. |
| 8 | Mount valves to inlet pipes and blowtube to valves, ensuring no excess thread sealant can enter the valve itself. |
| 9 | Apply moderate pressure to system and check for installation leaks. |
| 10 | Fully pressurise system. |
| 11 | Test fire and listen for proper actuation and crisp pulse noise. |
DIMENSIONS (mm):
Operation:
Recommended on time range: 50-500ms
Recommended time: between pulses: 1 minute or greater
Spare Parts:
K0380 Replacement seal armature spring & ferrule kit.
Product show:
