Zhejiang THOR Electric Co., Ltd |
|
LED street lamp, power supply, lightning protector, power supply, lightning protector, surge protector
Product introduction
The lightning arrester is designed for LED outdoor
lighting system. It can protect LED outdoor lighting power supply
system from lightning damage effectively. It has good lightning
protection performance, safety regulation performance and special
structure requirements, and can meet the lightning protection
requirements of LED power system.
Product specification
Model | TR6D | |
Rated Operating Voitage | UC | 275 |
Voltage protective level | Up(KV)≤ | 0.8 |
Max discharge current | Imax(KA) | 6 |
Nominal discharge current
| In(KA) | 3 |
Operating condition | Temp:-40℃~+70℃ | |
RH≤95%(25℃) | ||
Sea level elevation≤3km | ||
Remarks | Other max continuous operating voltage can be customized |
Working principle of product
When the surge protector has no voltage, the impedance
is very high, which means that the circuit breaker is open. When
the voltage occurs, the impedance drops to a few Europe, and the
surge current will flow through the surge protector and will not
enter the device. At the same time, because the surge protector has
a small impedance at this time, the voltage on both sides of the
surge is relatively small, and because he is in parallel with the
protected equipment, it prevents the equipment from suffering from
large surge power. Pressure, so as to play the effect of discharge
and pressure limiting.
Product features
1. installation is easy and easy to use
2. exquisite workmanship, able to work in bad environment
for a long time.
3. high efficiency, long life
Use of attention
1. grounding lines should be short, thick and straight,
so as to reduce the influence of distributed inductors on the
ability of lightning electromagnetic pulse.
2. in order to limit the inductive coupling between the
protected part after installation and the part of the unprotected
equipment, we need to make some measurements. The mutual inductance
can be reduced by the separation of the inductive source and the
sacrificial circuit, the selection of the loop angle and the
limitation of the closed loop area.
3. after correct installation, it can work steadily for a
long time. If it is found that the transmission performance of the
system is reduced or the signal is interrupted due to the cause of
surge protection, it should be maintained or replaced in time.
Company profile
Thor is all about protecting against the damaging
effects of power transients. It is our goal and mission to connect
our customer challenges with high-quality, right-priced solutions
and products – completed by unrivaled customer service and
technical support.
Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built
everything to offer a wide range of innovative and reliable surge
protection solutions and products.