Active Member
|
[China]
Address: Jiaoxi Industry Zone,Zhenglu Town,Changzhou City,Jiangsu Province,China.
Contact name:Mrs. Saffi Wang
Changzhou yimin drying equipment Co.ltd. |
|
|
SZG series double taper vacuum dryer for powder or granules drying with solvent recovery
Enamel or titanium tank for special matrial can be choosed.
Principle of Working
SZG series double taper vacuum dryer for powder or granules drying with solvent recovery has double cone rotating tank. Under the state of vacuum inside the tank, pass steam or hot water into its jacket for heating. The hot amount can contact with the damp raw material through its inner wall. The vaporized steam when the damp raw material absorbed heat can be pumped out through vacuum exhaust pipe. Because its inner of tank is in the state of vacuum and the raw material is turned over all the time caused by the rotating of tank, the dry speed of raw material is quickened and dry efficiency is raised too and the purpose of uniform dry can be raised.
Features
1. Saving energy source. Uniformly drying and finished product with good quantity
2. Widely used for materials drying in pharmaceutical industry, chemical industry, foodstuff industry, dyestuff industry and so on. It is in conformity with the requirements of "GMP".
3. Since the container runs continuously, the heating surface of the matter is always changed;
4. There is no any pollution because of indirect heating.
5. Thermal efficiency is high, over two times higher than that of normal drying over
Application
SZG series double taper vacuum dryer for powder or granules drying with solvent recovery is mainly used for drying following matters in medicine, chemical and food industries:
1. Matters with the residual volatile material which should be destroyed.
2. Matters with the discharged steam in drying which should be retrieved.
3. Strong irritant and poisonous matters.
Technical Parameters
| Model | SZG100 | SZG350 | SZG500 | SZG-7500 | SZG1000 | SZG1500 | SZG2000 | SZG3500 | SZG5000 |
| Volume (litre) | 100L | 350L | 500L | 750 | 1000L | 1500L | 2000L | 3500 | 5000 |
| Charging volume (L) | 50 | 175 | 250 | 375 | 500 | 750 | 1000 | 1750 | 2500 |
| Loading weight(kg) | 40 | 120 | 200 | 300 | 400 | 600 | 800 | 1000 | 1800 |
| Heating area(m2) | 1.16 | 1.5 | 2 | 2.63 | 3.5 | 4.61 | 5.58 | 7.5 | 13.8 |
| Rotating speed(rpm) | 3~13 | ||||||||
| Motor power | 0.75 | 1.1 | 1.5 | 2.2 | 3 | 4 | 5.5 | 7.5 | 15 |
| Rotating height | 1750 | 2100 | 2250 | 2490 | 2800 | 2940 | 2990 | 3490 | 4200 |
| Desigh pressure insider the tank: ---0.1~0.15Mpa | |||||||||
| Desigh pressure inside the jacket: ≤0.3Mpr | |||||||||
| Total weight (Kg) | 650 | 900 | 1200 | 1450 | 1970 | 2280 | 2500 | 2700 | 2900 |
Instructions to ordering
1. Its heating has three ways I.e. steam, hot water, heat
conduction oil;
2. When order, please indicate the temperature of raw material to
be undertaken or the operation temperature of drier in order to
choose or provide suitable heat source for you.
3. When dry viscous raw material, our factory will design special
stirring device in the chamber.
4. The auxiliary parts of vacuum drying system can be supplied and
installed by our factory. Please indicate them when order;
5. If having special requirements, our factory can also design,
manufacture and install as request;
6. The cost of complete equipment should be increased in accordance
with the needs.
