Fine Crusher product description
The fine crusher is suitable for
ultra-fine crushing operation with compressive strength less than
260Mpa, water less than 20%, feed size less than 60mm, and finished
product size 0.1-5mm. Such as crushing iron ore, quartzite,
potassium (sodium) feldspar, limestone, river pebbles, silicon
metal, barite, basalt, granite, steel slag, cement clinker,
construction waste (concrete), shale, lime, coal, coke, clay,
bentonite, chemical raw materials. It can be widely used in mining,
thermoelectricity, cement ceramics, metallurgy, chemical industry,
building materials and other industries, featuring low maintenance
cost, large crushing ratio, low water requirement, reliable
performance, low power consumption, low dust, low noise and so on.
The four crushing roll faces are divided
into surfacing roll face and flat roll face, which can be selected
and combined according to the granularity required by users.
Fine Crusher working principle
Fine crusher is the use of four wear-resistant alloy
crushing rolls, the relative rotation of the high pressure
generated by the crush to break the material. After the material
enters into the top two rolls V-type crushing chamber, it is
squeezed and ground by the relative rotation of the upper two rolls
for the first time (coarse crushing), and then it enters into the
middle two rolls V-type crushing chamber for the second time (fine
crushing), and then it finally enters into the lower two rolls
V-type crushing chamber for the third time (ultra-fine crushing) to
be crushed into the required granularity by the discharge port, of
which the middle two rolls are common rolls. The middle two rolls
are common rolls.Fine Crusher Technical Parameters
number | Model | Feed size (mm) | Output granularity adjustable(mm) | production capacity (t/h) | Motor power Kw | Protection mode | transmission method |
1 | 4PGS-10PT | <20 | 0.1-5 | 2-30 | 30-45 | sprung | triangle or coupling |
2 | 4PGS-30PT | <30 | 0.1-5 | 5-60 | 52-75 |
3 | 4PGS-50PT | <40 | 0.1-5 | 8-90 | 67-100 |
4 | 4PGS-60PT(Y) | <40 | 0.1-5 | 12-120 | 82-132 | Springs and hydraulics |
5 | 4PGS-80PT(Y) | <40 | 0.1-5 | 15-180 | 132-165 |
6 | 4PGS-100PT(Y) | <50 | 0.1-5 | 20-220 | 165-200 |
7 | 4PGS-120PT(Y) | <60 | 0.1-5 | 25-320 | 200-250 |
8 | 4PGS-150PT(Y) | <60 | 0.1-5 | 30-400 | 242-300 |
9 | 4PGS-180PT(Y) | <60 | 0.1-5 | 35-500 | 292-350 |