China refractory brick manufacturer factory Purging Plug porous
plug and wall Block for refining ladle and electric furnace(1) Good air permeability. Breathability is one of the important parameters to measure the
quality of purging plug. The research shows that the stirring
energy of molten steel is proportional to the flow rate of the
injected gas; stirring can directly affect the stirring efficiency
of molten steel, and only sufficient stirring energy can make the
molten steel have a good stirring effect. When the amount of argon
blowing is constant, the more argon bubbles are blown out, the
better it is for the degassing and stirring of molten steel.
(2) High temperature corrosion resistance. Refining ladle is very strict in terms of temperature and time,
the highest temperature often reaches above 1750 ℃, and the
refining time sometimes reaches tens of minutes. During the
refining operation, the slag alkalinity has a great influence on
the life of the purging plug. Therefore, the purging plug will be
eroded by the alkaline slag with strong permeability at high
temperature, and the damage speed is fast.
(3) High temperature wear resistance. When argon is blown at the bottom of the refining ladle, due to
the bottom blowing of argon, the flow rate of molten steel in the
ladle is very fast, and the erosion and wear of molten steel on the
furnace lining material and the purging plug bricks and well block
are significantly increased. When the ladle is hot repaired, in
order to remove the residual steel and slag on the surface of the
purging plug and restore the breathable function of the purging
plug, it is necessary to clean the surface of the purging plug with
oxygen blowing to melt the steel slag adhered to the surface of the
purging plug; gas to blow away the slag. During the cleaning process, the purging plug are scoured by high-speed airflow, so the purging plug are required to have good high temperature wear resistance.
(4) Good thermal shock resistance. Due to the intermittent operation of the ladle, when the ladle is
poured into molten steel, the end of the purging plug is subjected to the action of the high-temperature molten steel,
and the temperature rises suddenly. At the same time, when molten
steel is injected into the empty ladle, a large temperature change
will also occur, so the use conditions of the purging plug are very harsh, and it is very easy to produce thermal spalling
and structural spalling.
(5) It is required to be easy to install, safe and reliable. The purging plug is installed inside the base brick at the bottom of the ladle, and
the working conditions are extremely harsh. The life of the ladle purging plug cannot be synchronized with the life of the entire ladle, so the purging plug needs to be replaced. Therefore, it is required that the
installation and operation are simple, the use is safe and
reliable, and the occurrence of steel leakage and leakage events is
avoided.
