Active Member
|
[China]
Address: 2# Jinlong Rd. Baolong Industrial Zone, Longgang Dist. Shenzhen China 518000
Contact name:Tarik Lu
Forsentek Co., Limited |
|
|
Load cell transducer 20kg 10kg 5kg 2kg 1kg 0.5kg weight measurement sensor
Small size weight sensor FH02 is made of aluminum alloy based on strain gauge technology.Weight transducer FH02 offers 0.5kg / 1kg / 2kg / 3kg / 5kg / 6kg / 10kg / 15kg / 20kg nine rated capacities to choose from.Load sensor FH02 is temperature compensated to deliver stable readout throughout the working temperature range.Single point load cell transducer FH02 is corner trimmed for platform sizes up to 120x120mm,suitable for off-center load measurement.Beam loadcell FH02 is widely used for bench scales, weight monitoring laboratory equipment, home appliances, dosing machines and other weighing devices.
Dimensions
Specifications
| Rated capacity | 0.5kg 1kg 2kg 3kg 5kg 6kg 10kg 15kg 20kg |
| Rated output | 0.5kg @ 1.0mV/V |
| Excitation | 3-15V |
| Zero balance | ±5% R.O. |
| Nonlinearity | ±0.02% R.O. |
| Hysteresis | ±0.02% R.O. |
| Nonrepeatability | ±0.02% R.O. |
| Creep(5min) | ±0.02% R.O. |
| Safe overload | 150% F.S. |
| Ultimate overload | 200% F.S. |
| Compensated temperature | 0...+40oC |
| Operating temperature | -20...+60oC |
| Temperature shift zero | ±0.03% R.O./10oC |
| Temperature shift span | ±0.03% R.O./10oC |
| Input resistance | 410±30 ohms |
| Output resistance | 350±10 ohms |
| Insulation resistance | >5000M ohms |
| Ingress protection | IP65 |
| Material of element | Aluminum alloy |
| Cable | Ø3*400mm 4-core |
| Wiring code | Red--Excitation+ Black--Excitation- Green--Signal+ White--Signal- |
A load sensor is a transducer that converts mechanical force into
electrical signal which is proportional to the weight(or force)
being applied.The measured load or force causes deformation of the
measuring element(elastic body),the bonded strain gauge deforms
accordingly which will cause the resistance change of the
wheatstone bridge,under constant power supply,the output signal
between Sig+ and Sig- will change proportionally,thus the
load/force can be measured by measuring the output signal from the
load cell.
