Host part
(5) The rack adopts 16 # high-quality steel plate structure
1) Traction device:
(1) Structural type: active traction passive compression type
(2) The traction base adopts a casting structure (1 set)
(3) The traction roller adopts rubber rollers (specification: 4
pieces) φ eighty-five × 1150mm)
(4) The compression method adopts cylinder control
(5) The transmission guide roller adopts aluminum guide rollers
(specification: 3 pieces) φ seventy × 1150mm)
(6) The transmission guide roller can be tensioned up and down for
adjustment
(7) The motor adopts a three-phase asynchronous variable frequency
motor of 1.5KW (1 set)
(8) The frequency converter adopts 1.5kw Geetek (1 unit)
(9) Feeding is controlled by a conveyor belt
(10) The entire feeding mechanism is intelligently controlled by
displacement sensors.
2) Feeding mechanism:
1. Actively adopt servo control positioning method
2.4.4kw Inviton servo motor, driver (1 set)
3. The entire industrial control system adopts a digital industrial
control system driving method: the main motor drives the active
roller positioning
4. The transmission adopts synchronous belt and synchronous wheel
transmission mechanism
5. The feeding roller adopts an upper and lower smooth rubber
roller structure.
3) Cutting device:
(1) Cutting method: lower knife fixed, upper knife active cutting
(2) The cutterbed adopts a cast heavy structure:
(3) Linear guide rail (2 pairs)
(4) Oil container (2 pieces)
Lubricating oil can be recycled
(5) The upper and lower knives are made of imported balanced steel
knives (2 pairs) with strip knives
(6) Tool (specification thick × wide × Length: 15 × eighty ×
1150mm)
(7) The longitudinal cutting round knife is made of high-quality
steel (2 pairs)
(8) Operation method: Manually adjust the tool position
(9) Main transmission mode: The main motor transmission is matched
with a gearbox to drive the eccentric wheel linkage, and the
connecting rod reciprocates to move the cutting tool
(10) The main motor adopts a variable frequency speed control motor
in Shanghai (1.5kw)
(11) The frequency converter adopts Geetek (1.5kw 1 unit)
(12) The transmission adopts a synchronous wheel transmission
mechanism
(13) Eccentric wheel (2 sets)
(14) Connecting rod (2 pieces)
The material receiving platform adopts the automatic feeding
function of conveyor belts;
(1) The number of finished sheets is controlled by Panasonic PLC,
and the set number of sheets is automatically sent to the sorting
area. The machine automatically runs normally, making it easy to
operate and labor-saving
3. Electrical control part: (Control and host connected in
parallel) The entire machine adopts Panasonic PLC industrial
control system, and the touch screen is controlled by Taiwan Weilun
(1) The control system of this machine can be roughly divided into
host control.
(2) Host control: including main motor control, traction control,
feeding control, and cutting control.
(3) Equipped with an electronic meter counter for counting; Alarm
shutdown; Automatic fixed length, point in and point out functions.
(4) The above electrical components are selected from Chint; Switch
selected from Schneider brand
4. Supporting facilities: (user responsible)
(1) Electrical source: three-phase four wire air switch: voltage
380V/50Hz
Material discharge rack device;
