EPON GPON BPON LGX type 1x8 Optical PLC Splitter Low Polarization Dependent Loss

EPON GPON BPON LGX type 1x8 Optical PLC Splitter Low Polarization Dependent Loss

Fiber optic PLC splitter is one of the most important passive devices in optical fiber links. Optical splitter is an optical fiber tandem device with multiple inputs and outputs. It can connect local terminals and terminal devices and achieve optical fiber shunting. It plays an important role in FTTH passive optical network. With the continuous development of optical fiber communications, the demand for optical splitters will also be expanded. When using the optical fiber splitter, we should pay special attention to the protection of the fiber, and it is necessary to prevent dust and clean the fiber.

Before use, need to do the following prepared work: prepare anhydrous alcohol and wipe clean paper, prepare standard fiber optic adapter. It is best to prepare a portable light magnifier at least 200 times when the condition is allowed.

During use, disassemble the product package and check whether the fiber optic plc splitter is intact and whether there is a dust cover in the product channel. Then, select the corresponding optical fiber patch cord according to the model of the PLC splitter. Before the connection, clean the end face of the fiber optic jumper. Lay the alcohol wipe paper on the table, at least three layers. When cleaning, pay attention to wipe along the direction of ceramic face in one direction; do not wipe it back and forth, so as to prevent damage to the end surface.

After the cleaning is completed, distinguish the input and output ports of the fiber optic PLC splitter, then remove the dust cover and insert the fiber optic jumper. When installing the fiber patch cord, keep the key face of the connector consistent with the notch face of the fiber optic adapter, and insert it along the adapter level, then observe whether the white line on the connector is aligned with the fiber adapter side line and whether the installation is in place.

Finally, connect the input and output of the PLC splitter to the test system in turn, and check whether the optical index is in conformity with the requirements.

Parameters Of EPON PLC Splitter