2.5m*4.0m Ship Docking Pneumatic Yokohama Marine Fenders

2.5m*4.0m Marine Docking Rubber Fenders Yokohama Marine Pneumatic Bumper

Yokohama Marine Pneumatic Bumper

Yokohama marine pneumatic bumpers are widely used for ship-to-ship transfer, double banking, and ship-to-dock berths. They are preferably used in ports where the tides vary greatly. Jerryborg's Yokohama marine pneumatic bumpers can be easily deflated, enabling simple and cost-effective relocation, providing protection in dock and ship-to-ship mooring scenarios. We offer products in various sizes, and they can also be fitted with tires or chain nets to provide additional protection.

Yokohama marine pneumatic bumper is marine equipment used to prevent ships, ships, and other naval vessels from colliding with each other or crashing into docks, wharves, and piers. In other words, Yokohama marine pneumatic bumpers can be simply called marine bumpers.

Yokohama Marine Pneumatic Bumper Structure

① Outer rubber layer

The outer rubber layer uses special compounds that provide additional tensile strength and tear strength to protect the fender from severe weather conditions and frequent use.

② Synthetic-tire-cord layer

The Synthetic-tire-cord layer is made of synthetic-tire-cord fabrics, compared with synthetic canvas fabric and synthetic belt fabric, this reinforcement layer performs better in fatigue-resistance and pressure-holding.

③ Inner rubber layer

The inner rubber layer is specially designed to seal the internal air and prevent any leakage, just like the inner tube of a tire.

Yokohama Marine Pneumatic Bumper Advantage

1. Safe and Reliable

Yokohama marine pneumatic bumper is made of several strong cord layers to enable it to be pressure-resistant and puncture-resistant. The Yokohama marine pneumatic bumper whose diameter is over 2.5m is equipped with a safety valve to release the air inside in case it’s overpressured. The diagram below shows the data variations at different percentage compressions.

2. No Variation or Deformation in Performance

Yokohama marine pneumatic bumper is filled with the air of compressive elasticity inside, the deformation caused by fatigue is absent. In the experiment below of Yokohama marine pneumatic bumper, the performance variation will not happen if the pressure is maintained properly.

Our Yokohama marine pneumatic bumper remains the same without any variation or deformation even at temperatures under -50 degrees centigrade (-58 degrees Fahrenheit).

Yokohama Marine Pneumatic Bumper Application

1. STS sea transport.

2. Double banking and ships berthing at docks /jetty.

3. Oil and gas carriers.

4. Temporary and permanent installation.

5. Quick response and emergency.

6. Liquid cargo and naval defense ships.

Specifications of Yokohama Marine Pneumatic Bumper

Pneumatic 50 Standard Sizes:

Pneumatic 80 Standard Sizes:

For further information free to contact us.