Micro duct End Caps with Locking Clips

Microduct Connectors & Sealing

Direct Install – Blown Fiber Push-fit

End Caps with Locking Clips

Description

The end cap for permanent or temporarily sealing of unused microducts to prevent obstacles such as water, mud, dust and so on. The microduct end cap can also be used in conjunction with the Gas and Water Block Connectors during installation of microducts into existing ducts.

The body is transparent for easy fault location and fix the problem easily during installation.

Features

• Provides high-tensile, pressure-tight end seal for microducts
• Base body made of impact-resistant material (proven with spade test- followed by pressure test)
• Transparent base body for visual inspection of the connection
• Clamping teeth made of corrosion-free spring steel (tested according to EN 61386‑24 or EN 61386‑1)
• Pre-fitted locking clips prevent accidental disengage when installed
• Suitable for direct bury below ground and blow-in pressures up to 15 bar
• Internal pressure test according to DIN 16874 (170 h/80 °C/4.0 MPa)
• Can be removed and reused if necessary
• Also suitable for in-house use, flame-retardant according to EN 61386-22 and halogen-free

Structure & Material

Notes:

1. Please confirm the microduct outer diameter whether has damaged or scratches, connection face must be clean.
2. Please confirm the microduct outer diameter nominal tolerances meets土0.1mm.
3. Please make sure the connection microduct end face is cut into rectangular plane.
4. Please confirm the microduct should be through the sealing ring, have been pushed to the end of the joint, until it couldn't go far again.
5. After connecting the microducts, must check whether the duct can pull, then put into use.
6. When disassemble the microducts, please make sure the pressure is 0.

Specifications

Order Information