Smart Filtration Equipment Swimming Pool Controller With UV Chlorinator And Controller

Smart Filtration Equipment Swimming Pool Controller With UV Chlorinator And Controller

 
Description:

Swimming pool SPA water treatment unit adopts advanced automation equipment, in the form of room configuration requirements for assembly unit, save the site installation, material loss and room management fees, for customers with the best combination to solve family swimming pool, SPA pool, water treatment scheme.
* using sand cylinder filter, configure automatic control multi-way valve, can be controlled by means of pressure and time setting, changed the traditional manual control way of filtering, save time and effort
* with advanced disinfection system, as long as join the right amount of salt in the water, can make salt chlorine generator automatic chlorine disinfection, reduce the cost of traditional chemical disinfection and drug management; Low pressure UV sterilization to further improve the water sterilization effect, to ensure water quality, pollution-free, safe environmental protection
* configure automatic remote control electric control system, the user can remote control, easy and convenient

Note:

The sand cylinder can be selected according to customer demand acrylic cylinder cylinder or fiberglass sand sand
This equipment can according to customer request special selection, order.

Including:

* High quality side mount sand filter - high rate tanks are built to be tougher, longer lasting and better performing, with automatic multiport valve - innovated in the patterrn of the past manual control, applying the advanced microcomputer technique and the principle of pressure control and time control, linked with the automatic ball valve, automatically complete the work of wash and backwash.

* Double water disinfect - salt-water chlorinator and UV lamps, no need to add any chloriine.

* Remote control system - easy to operate, you can control the pump, the chlorinator, and the UV lamps even when you are swimming!

INSTALLATION:

1. Clear away any debris from the installation area, and make a datum mark before installation.

2. Place the unit in a proper position according to the installation detail drawing. Adjust the unit with a level to make sure the tolerance is less than 2mm, use the filter pieces to pack the unit level, fix the packing pieces, then fill in th vacant area with grout.

3. Connect drainpipe and cable pipe as shown in the installation detail drawing. The control box must be damp proofed. Electrical installtion and testing must be done by a licensed or certified electrician.

4. Fill in the joint between the unit and pool wall with grout when installing, and seal with sealant.

5. After installation, fill with sand around the unit body. Spread stones on the side of pool to match the pool structure, record the installation notes.