Langfang Lvshen Oil-gas oil separator can be also called Oil
precision oil separator or Oil fine separator, the most common
flange for our oil separator have one through and two through,
there are 3 types of flange, namely blank flange,perforated flange
and notch flange Replace Atlas air compressor oil and gas separator
AS2458 Langfang Lvshen oil separator is the key part of air
compressor, and it can decide the quality of compressed
air,High quality oil-gas separator should have the characteristics of complete oil and gas separation,small initial resistance,long service life and etc.Oil-gas separator can efficiently separate the oil out of the compressed air to insure exhaust high quality clean air.
Compressed air which come out of from compressed head will
carry large and small oil drop,big oil drop can be separated
through oil-gas separator tank, but small drop ( the diameter of
Suspended oil particles is below 1um) will must filter to pass
micron and fibre glass filter media layer of oil separator. Oil
small particles through diffusion effect will hold up by filter
material,and according to Inertial collision condensation etc
principle, make suspended oil small particles in compressed air
agglomerate together to form large oil drop. Under the action of
gravity,oil drop will flow direction to the bottom of filter and
accumulate together. Finally through the oil return pipe, and
reflow to the oil return tank. After the separation, the oil
content of compressed air is extremely low.Particles in the
compressed air intercepted by the media and detained on the media
result in the increase of pressure drop. The separator needs to be
replaced when the pressure drop is reached during 0.08-0.1Mpa,
otherwise the compressor machine will work at higher power cost.
1.Filtering precision:0. 1 Micron . 2.Oil contained in compressed
is below 3ppM. 3.Filtration efficiency:99.999%. 4.Service life is
approximately 3000h-6000h. 5.Initial pressure differential less
than 0.02Mpa. 6.Filter element of air oil separator is made by the
thin fiberglass,which imported from HV&Lyd Test Standard:
Cracking Resistance Standard is accordance with ISO 2941 Structural
Ntegrity Standards is accordance with ISO 2942 Material and liquid
compatibility standards ISO 2943 End load test standard is in
accordance with ISO3723 Filter element fatigue characteristic
standard ISO3724 Differential pressure flow characteristic standard
ISO3986 Multiple pass criteria for measuring filtration
characteristics ISO4572
