Name: Sany Crane Angle Sensor
Function: Mainly used in the leveling system of the crane's boom
and chassis.
The application of the angle sensor module on the lifting arm of a
crane is mainly to ensure safety considerations during operation,
allowing the safety system to have an early warning effect before
safety accidents occur. To reduce the occurrence of accidents,
manufacturers have developed some safety systems: safety load
displays, which are mature systems that can monitor changes in
cranes in real time. A necessary and crucial measurement for the
system to function is the angle of the suspension rod(
BoomAngle, the maximum range for this character is 90 degrees. It
is measured using an angle sensor
In addition, the crane needs to level the entire equipment chassis
before operation, ensuring operational safety and reaching the
maximum lifting capacity. This is achieved by measuring the
inclination angle of the chassis in various directions through a
dual axis inclination sensor module, and sending the output signal
of this angle to the PLC to drive the hydraulic cylinder to achieve
the levelness of the chassis. The angle measurement of the boom is
used to calculate the lifting height and prevent the entire
equipment from tipping over due to excessive lifting. This is also
a typical application of the tilt module in the leveling system of
the chassis of mechanical equipment such as cranes. It is
recommended to use a dual axis tilt module with a measurement range
of ± 90 ° in the chassis leveling system of the crane.