Face Milling Cutter CATE Tool Holder Lathe Machine Cutting Tool Holder

Lathe Machine Tool Holder CATEE Face Milling Cutter CATEE tool holder

To cut a CATEE face milling holder, you will need the following tools and materials:

- CATEE face milling holder
- Cutting tool (such as a hacksaw or bandsaw)
- Bench vise
- File or grinder
- Safety goggles
- Work gloves

Here are the steps to cut a CATEE face milling holder:

1. Put on your safety goggles and work gloves to protect yourself from any flying debris.

2. Secure the CATEE face milling holder in a bench vise, ensuring that it is clamped tightly and securely.

3. Determine the desired length of the CATEE face milling holder and mark it with a marker or scribe. Make sure to measure carefully to ensure an accurate cut.

4. Using a cutting tool such as a hacksaw or bandsaw, carefully cut the CATEE face milling holder along the marked line. Apply steady and even pressure to ensure a clean and straight cut.

5. After cutting, remove the CATEE face milling holder from the vise and inspect the cut edge. If there are any rough or uneven edges, use a file or grinder to smooth them out. This will help ensure a proper fit and prevent any potential issues during use.

6. Once you are satisfied with the cut and the edges are smooth, clean off any debris or metal shavings from the CATEE face milling holder.

7. Your CATEE face milling holder is now ready to be used. Make sure to follow the manufacturer's instructions and guidelines for proper installation and usage.

Remember to always exercise caution when working with cutting tools and machinery. If you are unsure or uncomfortable with cutting the CATEE face milling holder yourself, it is recommended to seek assistance from a professional or someone with experience in metalworking.

20CrMnTi Material CATEE40 FMB32 Face Milling Tool Holder ,the cutter bar clamping tungsten steel mold bar, the need to comply with all kinds of tool rod device description of. In order to avoid clamping precision caused by improper, distortion.CATEE Face Milling Holder used in the clamping of the cutter with the radial drive groove, such as the face milling cutter, the vertical disc cutter, the set type end mill, high speed and high precision machining .

CATEE Face Milling Holder SpecifiCATEEions

1. CATEE Face Milling Holder material:20CrMnTi

2. CATEE Face Milling Holder hardness:56-58

3. CATEE Face Milling Holder precision taper less than AT3

4. carbon depth less than0.8mm
5. CATEE Face Milling Holder pre-balance standard:G6.3 18000rpm,precision balance G2.520000rpm,25000rpm,30000rpm
6. Surface"environment protection",special coating surface treatment,improve the hardness and endurance of the surface,cleaness better,accuracy stable,surface

CATEE Face Milling Holder The positive benefit:

* to shorten the processing time, increase production per unit of time.
* the overall product precision, appearance quality.
* the production cost can be reduced.
CATEE Face Milling Holder Customer trust, under the orders of the chip increase