White Small Double Flush Toilet Button Circle Key Switch Customized Size

ABS toilet sanitary ware sanitary fittings galvanized white small double circle key switch

On the toilet top why is 2 button, press down to be able to go out water, but, what is the difference between these two buttons?

One, two buttons are different.

In the design of the toilet, two buttons on the water tank, one large and one small, the big button presses down to flush all the water, the small button presses down to flush half of the water.Don't blame me for my ignorance. I used to press the button whenever I pressed the button.

1. The two buttons on the toilet are half water and the other is full of water.Press large button to drain large amount;Small button displacement small.

2. Two flush buttons are used to save water.The big button is pressed after the big solution;The small button is pressed after the small solution.Large buttons can flush out solid waste.This will save water.

How to save water in the toilet tank?

Adjust the water level of water in the water tank there screw knobs, and an iron is iron picked in the middle of the plate of the iron is lower, down is high, you open the toilet cover, can see the inside of the ball linkage.There is a screw that you can see there are screws going up, you can meet your requirements.Low water level can save water.The easiest way to save water is to put one or two mineral water bottles filled with water in the tank, which can take up to 500 milliliters.

How to choose the toilet?

Buy a toilet commonly from the following consideration.

Will it stop?

There is no backwater bend in the design of the straight flush type toilet, and it is not easy to be blocked in the process of scour.The pipe diameter of the siphon type is about 56 centimeters or so, which is about three times less than the direct impact, so it is very easy to block the water.

Will the water spill out?

No one wants to be splashed with water at a convenient time, both in terms of health and psychology.The cause of toilet splash is a variety of reasons, such as: toilet structure, height, water intake Angle and use of human condition.The most important factor affecting splashing water is the height of falling, the higher the height of falling, the greater the speed of water inflow, the greater the momentum of water, and the serious splash of water.The experimental results of the researchers showed that when the height of falling was greater than 200mm, the splash water was serious, and the height of falling was less than 140mm. The critical height was 160mm.And falling height is made up of implement seat height is determined by the difference between its water seal, now implement seat height is according to the human body engineering design, general calf height and normal length.Therefore, the water seal is directly related to the problem of splashing water, and also is a barrier to the bad effect of the toilet.The national standard for toilet water seal is 50mm, generally good product water sealed between 55 ~ 60mm.So if you want to choose a toilet that is not easy to splash water, it is best to choose a toilet with a height of 55 ~ 60mm.

Save water?

It depends on two aspects, one is the water tank and the other is the bucket.The difference of the bucket part is the difference between the straight and the siphon, the direct impact water consumption is less than the siphon.Water is generally 6 litres of the following is the water-saving, less is not easy to rinse again, they are contradictory, and of course, is a kind of 3 litres of urine, 6 litres of move bowels, this kind of water saving.If you use 3 liters /6 liters of the toilet, it will be 1,350 liters per month, saving 1,890 liters of water per month, and reducing the amount of sewage discharged in 1890.