|
[China]
Trade Verify
Address: 2/F, A8 Building, Fu Zhong Industrial Park Fu Zhong Rd., Fu Yong Town, Bao An, Shenzhen 518103, China
Contact name:Viky
Shenzhen Waterun Technology Co., Ltd. |
|
Verified Suppliers
|
|
|
Auto Screw Feeder Driver Conveyor System Screw Counting Function Stainless Steel
Product Detail:
Technical Details:
| Model | Waterun-900D | |
| DC power supply | AC220V, DC12V 500MA, AC Adapter | |
| Applicable screw length(under head) | Up to 20mm | |
| Rail adjustment range | M1.0-M5.0 | |
| Speed of picking up | 1.5 sec/piece | |
| Product size | 180 x 125 x 150mm | |
| Weight | About 3kg | |
Introduction:
Problems and solutions :
| Malfunction | Reason | Solutions |
| Screw Feeder can't work | 1:Power supply broken,2:Switch is broken | Replace the broken part |
| Power indicator is on,but the machine can't work | 1:Front/back sensor block the signal； 2:The motor power cable is cut | 1:check and adjust 2:Rewelding the wire |
| Screw stuck in rail | Up and down brush . The gap between the rail or the position of high limited plate is wrong . | Making the adjustment after checking |
| Dropping the screw | The up/bottom adjust plate didn't installed very well | Adjust the position of the adjusting plate . |
| Vibrating all the time | 1:The speed of vibration is too big , and the setting delayed time is to long ； 2:Front/ back sensor was in the wrong place | Making the adjustment. |
| It is too slow to give out the screws . | 1:The screw feeder was put on the unflat place； 2:The speed of vibration is too small ； | 1:Re-adjust the angle of the rail ; 2:Adjust the speed of giving the screws .； 3:Lengthern the time of delivering and giving the screws . |
