LCD Display Slope Measurement GPS Land Meter For Mountain Area

New GPS Land Meter Land Measuring Instrument Mountain Area Measurement

Circle machine load area measurement Of GPS land meter

Circle machine load measurement function is used to measure area around the land, set the position of the land meter in the vehicle and the nearest distance of the ground boundary,and then measure the boundary around the region.Then measuring around the boundary of the land.

① At the Circle machine load in parameter setting,press the ▲▼button to set the edge distance;

② After setting is completed,press the "Start" to return main interface;

③ Press the▲▼button switch function to “Circle machine load”in the main interface;

④ In the main interface,press the【Start】button to measure at starting point .

⑤ Press the【Stop】button to pause measurement and view data after agricultural machinery work is completed；If the measurement is not completed,press the 【Start】 button again to continue the measurement. If the measurement is completed,press "Start" to save the data.

•Round-trip machine load

Round-trip machine load is used to measure the area of agricultural machinery back and forth work,put the Land meter in the middle of the vehicle width as far as possible,set the width of the front-end operation of agricultural machinery,and then carry out back and forth work measurement.

① At the Round-trip machine load in parameter setting,press the ▲▼button to set the width.

② After setting is completed,press the "Start" to return main interface.

③ Press the▲▼button switch function to“Round-trip machine load”in the main interface；

④ Press【Start】button at the starting point to start the measurement at the beginning of the work.

⑤ Press the【Stop】button to pause measurement and view data after agricultural machinery work is completed；If the measurement is not completed,press the 【Start】 button again to continue the measurement. If the measurement is completed,press "Start" to save the data.

Note: clicking "data" here will not display real-time data, and the current measured area must be calculated by clicking "pause".

• Length and width area measurement

① In the main interface,press the ▲▼to switching function to “Length and width”.

② At the starting point A press the【Start】button to measure,and press the【Enter】button to save the point A,go to the inflection point B,and press the【Enter】button to save the point B,go to the inflection point C,press the【Enter】button to save point C.

③ Press the【Stop】button to end measurement and view data,and press "Start" to save the data.

Note: if you want to end the measurement before 3 points are collected,Press the【Stop】button to pause the measurement.