Warehouse Storage Push Back Pallet Rack With Special Gravity Dustproof

Warehouse Storage Push Back Pallet Rack With Special Gravity Dustproof

Push Back Pallet Rack Introduction

Push back rack is a first-in-last-out storage system, suits for unified pallet goods. Push back rack system is a high density storage system. It can make most use of the warehouse space. In the same area, push back rack can store many more goods comparing with conventional pallet rack.

Push Back Pallet Rack Features & Benefits

1) Individual access to all pallets to full height of warehouse;

2) Elegant appearance, sturdy and durable;

3) The system is also speedily installed and simple to adjust;

4) The beam levels are adjustable by 75mm;

5) Lower level pallets can be located on the floor (picking pallets;

6) Accessories available can accommodate every unit load type.

Push Back Pallet Rack Features

• First-in-last-out mode

• Large storage capacity and extremely high space utilization

• Suitable for multiple varieties and large quantities of goods

• Suitable for situations such as freezer that need to greatly improve space utilization

Push Back Pallet Rack detail

Cart - Bearings – Rails – Anti-Slip Steel – Rail Bracket – Front Stopper

Push Back Pallet Rack function

Push-back rack, also known as push-in rack, are connected by multi-layer carts between the front and rear beams. Stacked goods are pushed into the carts from the outside, and the stored goods will push the original goods into it. It is usually used in places where the storage space is extremely limited, but the storage capacity must be increased or the time required for the goods must be increased.

The track of the press-in rack has a certain slope, about 3 °. It uses the weight of the goods, and the pallet goods are specified for single-end storage. The total depth of this kind of rack should not be too deep, generally within the depth of 6 pallets, because the carts are embedded in each other, so they take up some space. The weight of a single pallet is generally within 1500kg, and the rack height is generally below 6m.

The press-in racking system has higher requirements for the manufacturing accuracy of the rack. Because the cooperation between the pallet cart and the guide rail is high, the manufacturing and installation accuracy is strict. Failure to do so will cause the racking system to run poorly and affect work effectiveness.

The cost of press-in rack is higher, which is directly proportional to its value. Its warehouse utilization rate reaches about 80%, and the space utilization rate of the warehouse can be improved.

It is more than 30% high, easy to access and flexible, and is the rack with the highest storage efficiency.

Design Features

The track of the press-in rack has a certain slope, about 3 °. It uses the weight of the goods, and the pallet goods are specified for single-end storage. The total depth of this kind of rack should not be too deep, generally within the depth of 6 pallets, because the carts are embedded in each other, so they take up some space. The weight of a single pallet is generally within 1500kg, and the rack height is generally below 6m.