Stator Slot Electrical Resin coating Electrostatic Fluidize Coating System

Stator Slot Electrical Resin coating Electrostatic Fluidize Coating System WIND-JF

This stator powder coating machine composed of pre-heating zone, cooling zone, coating zone and curing zone,

electrostatic powder/resin coating is widely used in micro rotor insulating coating,

such as automotive, motorcycle, electric bicycle, toy and small electromotor of home appliances.

Application:

Coting process:

This electrostatic powder coating is divided into three process,

1.They are resin coating,

 2. Remove excess powder by scratching device of motor armature or stator surface,

3. Curing.

This powder coating process be done on the electrostatic fluid bed,then the scratching deive clean powder, after scraping, the armature/rotor or stators pass high-frequency induction heater to curing, in this way, the powder can be applied to an object, bonding to the substrate and coalescing into a smooth, continuous, essentially uniform, thick coating. Use resin 3M or AkzoNobel include moisture-proofing and insulating armatures, rotors, stators,bus bars and other motor parts. This electrostatic powder coating machine contains a powder recovery recyling device, The device comprise a dust suction pipe disposed corresponding to the coating device, the powder cleaning device and the device located in the electrostatic powder coating machine frame. The separate dust suction pipes are concentrated to the total dusting collecting pipe.The total dusting piple send powder to cyclone separator, Upper of the cyclone separator is an outlet pipe, and lower end is a powder collecting piple which connected to powder feeder. With the three stage recycling device, this machine can hold the powder or resin and friend to environment.

Parameter:

Armature/Stator OD:  15mm ~ 50mm 

Core length: 8mm~60mm

Shaft length: 2mm ~ 8mm

Output: by customer request

Coating thickness: 0.15-0.5mm adjustable

Armature/Stator transfer speed: 0.1-15.meters per minute