ASTM A240 Stainless Steel Plate 8MM S32205 Heat Resistant Inox Sheet

ASTM A240 / A240M Stainless Steel Plate 8MM S32205 Heat Resistant Inox Sheet

Product Introduction

ASTM A240/A240M Middle thick stainless steel and 2205 duplex stainless steel sheet forming shall be carried out below 600 ° F. During hot forming treatment, the whole workpiece shall be heated as a whole and shall be carried out in the temperature range of 1750 ° f to 2250 ° F. 2205 alloy is very soft at this temperature. If the temperature is too high, 2205 alloy is prone to hot tearing. Below this temperature, austenite will fracture. Below 1700 ° F, the intermetallic phase will form quickly due to the influence of temperature and deformation. After hot forming, it shall be subject to solid melt annealing at a minimum temperature of 1900 ° F and quenching to restore its phase balance, toughness and corrosion resistance. We do not recommend stress relief, but if this is necessary, the material should be solid melt annealed at a minimum temperature of 1900 ° F, then rapidly cooled and water quenched.

Product Show

Surface Treatment

Certificate

Packaging Details

1. Sheets covered with wooden plate for protection in transportation.

2. All sheets will be loaded in strong wooden packages.

3. Every cartons loaded with good shoring and strengthening.

4. Take container loading pictures and seal the container.

5. Transportation speed is quick. And keep customer each step informed.

F&Q

Q: ARE YOU FACTORY OR TRADER?

A: Hengchengtai Special Steel is a cold rolling manufacturer of magnetic stainless steel coil since 2009. We've gained our Export Right and become an integrated company of industry and trade in order to satisfy buyer's multi-request on different material and products.

Q: WHICH MATERIAL/PRODUCTS YOU CAN PROVIDE?

A: Stainless Steel Coils / Strips, Stainless Steel Sheets / Plates, Stainless Steel Circles / Discs, Decorative Stainless Steel Sheets.

Q: HOW TO GET A SAMPLE?

A: FREE samples are available for your checking and testing. And to get free samples, you need to send us you detailed receiving address (including post code) and your DHL/FedEx/UPS account for collecting samples, courier cost will be paid in your side.

Q: HOW TO VISIT YOUR FACTORY?

A: Most of the main cities have flights to Wuxi; you can take flight to Wuxi Shuofang International Airport.

If you come from Shanghai, it will take 2 hours by flight (every day 5 flights).

If you come from Hongkong, it will take 1 hour by flight (every day 1 flight around noon time).