Eye Care Skin Tightening Hydrafacial Microdermabrasion Machine OEM

1. Checking the device, turn it on if there is no problem, make sure the device is working properly.

2. Using 75% alcohol to disinfect the energy output surface of the treatment head (the surface in direct

contact with the client's skin).

3. Adjusting the appropriate parameters on the interface (pulse time and energy are adjusted from low,

the mode is adjusted according to the beautician's operation mode and usage habits, it is recommended

to use the single-shot mode), after the adjustment is completed, start the function on the interface (switch

STAND BY to PAUSED), allowing the operator enough time to cool down in advance.Wrapping the client's

hair, then remove makeup and clean the operating area (face).

4. Apply the gel to the client's face, or apply the gel to the energy output surface of the treatment head.

When operating, it must be ensured that there is enough gel as a medium in the operating area. If it is

not enough, please reapply in time.

5. Wearing disposable gloves.

6. The energy output surface of the treatment head is close to the skin, and then start the operation

through the handle start button or the foot switch. When the energy is output (the handle indicator light

is on, there is a sound prompt), move slowly, and the energy output is completed (the handle indicator

light is off, there is a sound prompt) ) to stop the operation. The pulse time and energy should be adjusted

according to the real-time feedback of the customer, and it is advisable to have acceptable energy and

obvious warmth.

7. Moving the handle to the next area and use the method in point 8 to operate, and so on, until all the parts

to be operated are completed (please refer to the operation method for the specific method).

8. Replacing the treatment head and operate according to the methods in points 6, 8 and 9.

9. After the operation, apply the mask on the operation site for 15-20 minutes.

10. Using a wet cotton pad to wipe off the product remaining on the customer's operating site.

11. Cleaning the residual product on the handle and the treatment head, and then use 75% alcohol to

disinfect the energy output surface of the treatment head.

12. Removing the treatment head from the handle and place the energy output side up.

When the device is turned off, the surface of the host can be wiped clean with a wrung wet cloth.

Accessories list