10m/Min Drywall Roll Forming Machine C steel profile

10m/Min With Perforation Metal Montant Roll Forming Machine Export Argentina

1. The top and bottom should be along the top keel and along the floor keel.(drywall system roll forming machine)

2. Vertical keel should be used in the vertical direction and reinforced keel should be used in the door frame area. (Track roll forming machine)

3,There should be horizontal support keel.

4,The accessories are support cards, card brackets, corner brackets, connectors and fixings. One of these materials is indispensable. (Stud roll forming machine)

5, along the top keel, along the floor keel should be fixed according to the location of the bullet line, fixed by shooting nails, expansion bolts, etc., nail distance is not greater than 600mm.

6, against the wall, column vertical keel available nails, expansion bolts or wood screws and wall, column fixed, nail distance of not more than 900mm. (Wall angle roll forming machine)

7, the middle vertical keel should be in accordance with the width of the cover panel, to not more than 1/2 board width plus the width of the gap (generally 5 mm) set in grades, the spacing should not be greater than 600mm, the two ends of the application of nails fixed.

8,When two partition walls are connected longitudinally and horizontally, the vertical keel of the intersection part cannot be omitted.(drywall system roll forming machine)

9, horizontal support keel available support card, card bracket and connector connection fixed, if necessary, can be fixed with core rivets, but shall not be welded with electric welding.

10,The spacing between horizontal braces should not be greater than 1200mm.

11,The keel must be set at the joints of the cover plate. (Stud roll forming machine)

12,The keel shall not be arbitrarily cut or reduced in section.

Flow chart of two profiles one machine:

Manual decoiler--Guiding--Guiding--Roll forming--Hydraulic flying punch--Hydraulic flying cut--Out table

LINBAY MACHINERY exported this MONTANT machine to Argentina, which can be made in three sizes: MONTANT 35, MONTANT 70,MONTANT 100, with different bottom widths that can be achieved by changing the casing. In the MONTANT100 size, the production speed is 11 meters per minute when punching 4 times for every 3 meters of profile, and 30 meters per minute when producing every 3 meters of profile without punching. The production speed is very fast and suitable for production companies with large production.

Pictures of stud and track roll forming machine: