* WIDE RANGE OF APPLICATION – This foam gun is perfect for any caulking project, ideal for
filling, sealing and insulating small gaps,suitable for balcony
doors, windows, bathtub, cabinet etc. No squeeze wall and pipe,
waterproof and moisture-proof, and prevent pests from entering the
room.
* EASY TO CLEAN - The PTFE Material non-stick canistheer adaptor, needle, check
valve,gun body are very easy to clean. Just need to clean the gun
each time once finish using to extend its life.
* USER FRIENDLY - The foam gun is made of perfluorocarbon which can keep the gun
clean and durable.Inlet valve, delicate thread make it easy to load
and unload and not easy to leak foam.The Ergonomics handle is made
of ABS plastic which is very comfortable for long time use.
* PRECISION SPRAYING - This Foam Gun allows expanding foam to be applied quickly and
with precision. Spring trigger and control knob allow you to
control flow accurately,avoid foam waste, adjust spray
distance.This gun is also perfectly compatible with Great Stuff
Pro, Touch‘n Seal, Fomo Handi-Foam, Handi-Stick, Seal Pro Guns.
* ORDER WITH CONFIDENCE - GREATCAULK is committed to providing better product and service. If for any
reason you are not satisfied with the product, simply contact us
and we'll give you a satisfactory solution.PTFE coated for greater non-stick and reliable performance, easy to
clean.
Adjustable foam bead control allows variable foam bead size
control.
Includes two fine foam dispensing nozzles for foam application in
hard to reach areas or in tight spaces.
Specifications:
Material: PTFE coated,aluminium alloy body
Weight: 314g
Length:32cm
Height: 18cm
The Maximum output pressure: 8 MPa
The Maximum injection flow rate: 5L/min
Spray width: 3mm
Package Included:
1 x Expanding Foam Gun
2 x foam dispensing nozzles
1 x Long Plastic Tubes
Usage:
1. Taking a bottle of vesicant, holding the middle of the tank body
by hand, shaking the can body along the horizontal direction for at
least 20 times to ensure that the tank pre-polymer fully mixed.
2. Removing the detergent on the foaming gun, taking off the cover
on the threaded valve of the vesicant, screwing the vesicant tank
to the foam gun interface along the thread
3. Gripping the foaming gun to ensure that the vesicant tank is on
the top and the foam gun is under the tank, and then openning flow
control valve of the rear of the foaming gun.
4. The tip is aimed at the bottom or inside of the part to be
filled.It will start the construction when gently pull the
trigger.It can be adjust to the appropriate flow through the flow
control valve behind the foam gun.
5. After a tank of spray, if you want to fill, you can immediately
remove the empty cans, according to the step 3 to re-install the
vesicant to continue construction.
Note: Please clean it with Polyurethane foaming gun cleaner after
each use.
1.Clean the exterior and gun tip
2.Spritz the Basket Attachment
3.Then replace the cleaner to flush the interior until foam gone.
