Active Member
|
[China]
Address: Bairong Road and Xingyuan Road, Erqi District, Zhengzhou city, China
Contact name:Thomas Wang
HENAN TMS MACHINERY CO., LTD |
|
|
Blue Output 300-400kg/h Scrap Copper Wire Recycling Cable
Granulator Machine
Introduction
Copper cable granulator and separator is used for
recycling scrap copper wires/cables with diameter less
than 25mm, better for single conductor diameter of 0.2-0.5mm.
The wire is like auto wires, communication cables and kinds of
miscellaneous wires and cables.
copper wires are shredded by crushers, then
plastic and copper granules are separated by vibration and
airflow. They come out from different outlets, dust is
collected by dust collector. The copper granules and plastic
granules will be separated by small vibrator twice time. The
recovery rate can reach 99.9%.
| Model | Dimension (mm) | Total Power (kw) | Capacity (kg/h) | Weight (kg) |
| Mini-400 | 1500*1500*1900 | 11.92 | 100 | 750 |
| TMS-400 | 2700*1900*2300 | 23.12 | 150-200 | 1200 |
| TMS-600A | 4000*1950*2300 | 48.36 | 300-400 | 3400 |
| TMS-600B | 4300*1950*2400 | 52.36 | 300-400 | 3400 |
| TMS-800 | 9200*4100*2400 | 78.76 | 500-800 | 8000 |
| TMS-1200 | 16000*10000*3000 | 129.36 | 1000-1500 | 12000 |
After-sale
1. The machines except spare parts are guaranteed for 12
months.
2. Engineer will be sent to your place to guide how to operate for
the production line.
3. We will send you extra set of spare parts and two sets small
vibrators.
Protective Devices
1). There is a protective baffle inside the material inlet to
prevent crushed material from casting out of the feeding mouth.
2). High-speed rotating flywheels and belt transmission parts are
covered with fixed protective covers.
Noise Level
1). The machine’s unloading noise level is below 80dB.
2). Special Note: when the machine is working, the noise would
increase as the machine’s working load is increasing, so the
operator must wear protective earplugs in working.
Use & Maintenance
In the case of correct selection of machines, the service life also
depends on appropriate use and timely maintenance. High temperature
complex lithium base grease is used for bearings, so they are high
temperature resistant, good at impact resistance, have a long
service life. According to the actual use, users shall regularly
inject grease. When Chopper blades get blunt, remove the blades and
sharpen them with a blade sharpening machine, and adjust the
spacing between fixed blades and rotating blades to 0.15mm-0.25mm.
The grease for bearings should be replaced every 300 working hours,
and grease for chains shall be added every 15000 working hours.
