1. Basic treatment:
Clean the surface of the site with a broom and a high-pressure
water spray gun, fill the gaps on the foundation surface with
professional caulking materials, sprinkle the site evenly with tap
water, observe the drainage and water accumulation, and mark the
water accumulation with a colored pen. If there is a protruding
part , use professional tools to level it, and after natural
drying, use professional repair materials to repair the water
accumulation.
2. Pay-off positioning:
First determine the four curved and straight dividing lines, and
lay out the lines on the straight section of the sports field. The
marking lines should be in bright colors. Based on the curved and
straight dividing lines, release the first construction line along
the inner edge, and then release the construction lines in sequence
from the inside to the outside. Wire.
3. Rubber coil laying:
After the construction markings are drawn, start from the inner
edge of the runway based on a curved and straight dividing line,
align along the drawn construction markings, and place the runways
in sequence. The horizontal pressure head should be 200 mm, and the
longitudinal runway should be aligned It is appropriate. The rolls
are laid from the inside out.
4. Bonding of rubber runway coils:
After the runway is set up, roll up the runway from both ends
before bonding, and scrape glue on the ground from the center of
the rolled up runway in one direction. When squeegeeing the ground,
the amount of adhesive should be moderate, and should be controlled
between 0.7-1 Kg/m2 per square meter. The scraping should be
uniform, the viscosity of the adhesive should be well controlled,
and the laying should be carried out within the best time.
5. Coil surface pressing:
After the runway is bonded to the ground, in order to ensure that
the runway and the ground are firmly bonded, and to prevent the
edge of the runway from warping, it is necessary to perform joint
pressing of bricks.
6. Port cutting:
When gluing the end face interface, one end of the runway should be
pressed firmly with a steel ruler and trimmed. The upper pressure
runway and the lower pressure runway are at the ports. The
shrinkage at low temperature should be considered when bonding, so
that the upper and lower pressure plates have a margin.
7. Clean up the site:
After the runway is bonded and the adhesive is fully cured, clean
the site, check the interface of the runway port at the same time,
repair the weak or uneven area in time, and prepare for the next
process.
8. Draw a line:
After the field has been repaired and cleaned, the 5CM white line
on the marking machine cover will be drawn.
Why we make choice to buy SPU sports surface flooring material from
your factory?
Because our SPU sports flooring surfaces offer numerous advantages:
- High UV weather resistance
- Maximum abrasion resistance and permanent elasticity
- High degree of adjustable area elasticity and point elasticity
- Spike resistance even under constant load
- Long life,permanent bond with case
- Entire installation form one single partner,from the earthworks
to the construction of the sub base and finally the
synthetic coat
- Dedicated teams using state-of-the -art construction techniques
install the right system professionally and on time
- We cover the intire range of installation requirements,from
all-weather surfaces for school SPU sports flooring surfaces
to high-performance surfaces for competitions and
tournaments-cost-effectively,efficiently and quickly.
- High - grip or nonslip surfaces.systems can be adjusted to be
water-permeable or water-impermeable.consistent sports
conditions,even under extreme temperature and weather
conditions.the surface and usable within minutes after rain
shower.
- Numerous design options,e.g.by using contrasting colors in
selected areas without need for joints.
