15mil TMM10 Rogers PCB Board With Green Solder Mask For Chip Testers

Rogers 15mil TMM10 High Frequency PCB With Immersion Gold and Green Solder Mask for Chip Testers

(Printed Circuit Boards are custom-made products, the picture and parameters shown are just for reference)

Rogers’ TMM10 thermoset microwave materials are ceramic, hydrocarbon, thermoset polymer composites designed for high plated-thru-hole reliability stripline and microstrip applications.

TMM10 laminates' electrical and mechanical characteristics combine many of the advantages of ceramic and conventional PTFE microwave circuit laminates without the need for the specific manufacturing processes typical of these materials.

The thermal coefficient of dielectric constant of TMM10 laminates is typically less than 30 ppm/°C, which is extremely low. The material can produce high reliability plated through holes with minimal etch shrinkage values thanks to its isotropic coefficients of thermal expansion, which are extremely closely matched to those of copper. Additionally, TMM10 laminates' thermal conductivity is about twice as high as that of conventional PTFE/ceramic laminates, making it easier to remove heat from the system.

The thermoset resins used in TMM10 laminates prevent them from softening when heated. As a result, there is no need to worry about pad lifting or other issues while wire bonding component leads to circuit traces.

Some Typical Applications:

1. Filters and coupler

2. Power amplifiers and combiners

3. RF and microwave circuitry

Our Capabilities (TMM10)

Data Sheet of TMM10