Constant temperature mixed water valve
Thermostatic Mixing Valve
Working principle
A heat sensor is installed at the water-outlet of the constant
temperature mixed water valve, the valve core in the valve body is
moved by the temperature sensor to block or open the cold, hot
water-inlet. The hot water opening is increased while the cold
water opening is decreased, when the temperature adjusting knob
sets a certain temperature, the cold, hot water ratio at the
water-outlet will be changed as well regardless of the change of
the cold water-in or hot-water in temperature, therefore, the
constant water-out temperature is ensured.
Max. working pressure: | 1Mpa |
Ideal working pressure: | 0.1-0.6Mpa |
Hot water temperature: | 50~80ºC |
Max. water temperature: | 100 ºC |
Adjusting scope: | 30-55ºC-65ºC |
Temperature control accuracy: | ±2ºC |
Coldhot water-in pressure differential: | 8:1 |
Through-diameter | G1/2"G3/4" |
Flow: | 1m3/h~20m3/h |
There are two arrows on the adjusting knob, which point to 30ºC and
55ºC respectively, which means the turning direction for
temperature increasing and reducing. When it is the first time to
set temperature, please adjust from the low temperature to high
temperature to prevent scald. The end of the low temperature
direction is to close hot water, while the end of the high
temperature direction is to close cold water, It is possible to
take bath by closing cold water and using hot water, if the hot
water temperature is not high enough, but it is required to being
adjusted to the low temperature after using to prevent scald when
used next time.Position | Min | 1 | 2 | 3 | 4 | 5 | 6 | 7 | Max |
Temperature(ºC) | - | 30 | 34 | 39 | 43 | 47 | 51 | 55 | - |