Active Member
|
[China]
Address: No. 1617,16TH Yichuang street, Jiulong Avenue, Huangpu District, Guangzhou City, Guangdong, 510700, P.R. China
Contact name:Sylvia
Guangzhou Shusen Trading Co., Ltd. |
|
|
UHP280W 0.8 E19.7 Bare projector lamp SONY Projector Bulbs Original
new LMP-C281
UHP280W 0.8 E 19.7 SONY projector bare lamp , all items are 100% new and pass
the quality checked. And will be packaged in good condition before
dispatch. 100% Brand New, Premium quality, high
brightness, long life replacement projector lamp. Compatible for VPL-CH373,VPL-CH378,VPL-CH370,VPL-CH375,VPL-F535H,VPL-F530H
| Product name: | Projector Lamp |
| Model No. | UHP280W 0.8 E19.7 |
| Condition: | 100% Brand new |
| Type: | Compatible Bare lamp |
| Lamp power: | 280W |
| Life time : | ≥2000-5000HourS |
| Used in the these projector: | VPL-CH373,VPL-CH378,VPL-CH370,VPL-CH375,VPL-F535H,VPL-F530H |
| Installation: | Easy installation. |
| Warranty: | All items have been QC tested and 90 days Warranty at least |
| Package: | Each lamp in a single box with foam protection. One pair gloves and instruction inside. |
If you want your Projector Lamps work longer, please Note:
1. Do not allow the projector to overheat; the primary cause of
lamp failure is excessive temperature stress.
2. Allow the projector lamp to cool for at least 10 minutes after
powering down, and never move the projector during this period or
while the lamp is on. The lamp is much more susceptible to damage
while it is hot.
3. Operate your projector in a clean, relatively dust-free
environment to prevent clogging of fans and air filters. These
filters should be cleaned regularly.
4. Allow plenty of space around the projector's fan or exhaust so
excess heat can be dispersed properly.
5. Utilize the "economy mode" if it is available with your
projector model and is appropriate for your situation. This mode
decreases projector brightness but the lamp will last longer.
6. Never leave a projector in very hot or very cold environments,
for example in a car on a summer or winter day.
Installation:
1. Turn off the Projector and unplug the AC power cord.
2. Loosen the screw on the lamp cover with a screwdriver, and then
open the lamp cover.
3. Loosen the 2 screws on the lamp with the screwdriver. Hold up
the handle, then pull the lamp straight out.
4. Hold the handle of the new lamp and push it in securely until it
reaches the end, and then tighten the 2 screws.
5. Close the lamp cover, and then tighten the screws
6. Plug in the AC power cord.
