Active Member
|
[China]
Address: China Zhejiang Wenzhou Economic Development Zone
Contact name:
Zhejiang THOR Electric Co., Ltd |
|
|
A three-phase self duplex undervoltage protector for photovoltaic 380V is automatically restored to overpower
Product introduction
Solar surge protector is a kind of surge protector, which is mainly
used for lightning protection measures adopted in photovoltaic
system. It is an important manifestation of internal lightning
protection. According to the characteristics of photovoltaic
system, we use multi-level protection to maximize the voltage into
the underground, so as to achieve the role of lightning protection
and overvoltage.
Product features
1. beautiful appearance, fine work
2. troubleshooting, automatic closing
3. operation is simple and clear
4. create the wiring connection to prevent incorrect
contacts, and add a guarantee to your safety.
Product specification
1. Rated Operating Voitage(UC):500V
2. Voltage protective level(UP):1.8KV
3. Max discharge current(IMAX):40KA
4. Nominal discharge current(IN):20KA
5. Ressponse time(NS):<25
Working principle of product
In the solar photovoltaic system, the inductive or capacitive
coupling voltage is caused by the lightning shock and the switching
operation of the upstream power supply system. Therefore, the surge
may damage the photovoltaic modules and inverters, which will cause
serious consequences for the operation of the photovoltaic system.
The photovoltaic lightning arrester is specially developed for this
purpose. The lightning protection module of the DC power supply,
once the high voltage, and endanger the insulation of the protected
equipment, the lightning arrester acts immediately, and the high
voltage impact current is directed to the earth, thus limiting the
amplitude of the voltage and protecting the insulation of the
equipment. When the overvoltage is gone, the arrester is restored
to its original state quickly, so as to protect the power
equipment.
Use of attention
1. the standard RJ45 interface can be conveniently
connected to the front end of the protected device, and the
grounding path should be as short as possible, and the length
should not exceed 1.5 meters.
2. when installing, pay attention to cables coming in
and out of surge protective devices, so as to avo id the two
coupling of surge.
3. the protected equipment must have good grounding,
and the grounding impedance is in accordance with the relevant
national standards.
4. After correct installation, it can work steadily for a
long time. If it is found that the transmission performance of the
system is reduced or the signal is interrupted due to the cause of
surge protection, it should be maintained or replaced in time.
Company profile
Thor is all about protecting against the damaging effects of power
transients. It is our goal and mission to connect our customer
challenges with high-quality, right-priced solutions and products –
completed by unrivaled customer service and technical support.
All types and classes of our lightning and surge
arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and
pass all the requirements based on their class.
Product packaging:Carton packing
Transportation method
2. Trains, ships, aircraft transport
