Active Member
|
[China]
Address: Changjing Town, Jiangyin City, Jiangsu Province, China
Contact name:Ricky Lee
Jiangyin Xinda Medicine and Chemical Machinery Co.,Ltd |
|
|
XKP Radial Steel Tire Raw Rubber Recycling Machine
Description:
This is a double roll granulating and rubber-mixing machine. It
consists of motor, gear-down reducer, driving gears, speed-ratio
gears, front and back rolls, bearings, frame, cover, bed plate,
adjusting pin device, emergency stop device, roll temperature
adjusting device, lubricating device and material plate, etc.
Front and back rolls are parallel mounted in the bearing of frame.
By means of reducer, driving gears, speed ratio gears, the motor
drives the front and back rolls rotate toward each other so that
rubber-cracking is begun. The rolls are made from chilled cast
alloy iron; The inner of it is hollow. Steam and cooling water can
pass through them so that the surface temperature can be adjusted.
Its surface possesses higher hardness and fineness.
Roller bearing, copper bushing is fixed in the bearing base of
frame. Back roll bearing bases are fixed up on frame, and the front
roll-bearing base can slide in the guide-rail of frame.
Roll spacing adjusting is carried out by means of the reverse of
hand wheel makes the thread rod drive front bearing base movement.
The roll pin reduces when the hand wheel rotates clockwise,
otherwise it will increase.
The emergency stopping device is mounted in the frame. In abnormal
situation, pulling the rod, via dynamic, the machine is stopped
immediately.
Adjusting temperature device is two spray pipes with numeral rows
of holes, extend the two pipes into the hollow roll, the holes are
in the position of working section of the roll. The position of
holes slants to 30 degree inner direction so that the spraying
water and steam is directed at contacting angle of sizing material,
this can control the surface temperature of roll.
Applications:
The machine is to be used for raw rubber cracking and scrip rubber cracking in rubber industry.
| Model: | 560*800 |
| Capacity(Kg/H): | 600~800 |
| Working diameter(mm): | Front 560 Rear 510 |
| Feeding size(mm): | <=30~60 |
| Output size(mm): | <=5~30 |
| Motor Power(Kw): | 110 |
| Main shaft speed(RPM): | 32 |
| Weight(T): | 15 |
