|
[China]
Trade Verify
Address: 608, Building B, Yinyi Duhui Guoji, No.8, Lane 559, Youngor Avenue, Haishu District, Ningbo, China
Contact name:Brandon Bao
Ningbo Brando Hardware Co., Ltd |
|
Verified Suppliers
|
|
|
1/4'' Plug Connection Direct Acting Plastic RO Solenoid Valve
BPV03 1/4'' Plug reverse osmosis solenoid valve.Valve body made by PP material.
Polypropylene (PP), also known as polypropene, is a thermoplastic polymer used in a wide variety of applications. It is produced via chain-growth polymerization from the monomer propylene. Polypropylene belongs to the group of polyolefins and is partially crystalline and non-polar.
Pilot Solenoid valve:
When energized, the electromagnetic force first opens the pilot
hole, the pressure in the upper chamber drops rapidly, and a high
pressure difference is formed around the closing part. The fluid
pressure pushes the closing part to move upward and the valve
opens; when the power is off, the spring force pushes the pilot
hole When the valve is closed, the inlet pressure quickly passes
through the chamber through the bypass hole, forming a low and high
pressure difference around the valve closing member, and the fluid
pressure pushes the closing member to move downward to close the
valve.
Direct acting solenoid valve:
When energized, the solenoid generates electromagnetic force to
lift the closing member up against the valve seat sealing water
port, and the valve opens; when power is off, the electromagnetic
force disappears, and the spring presses the closing member back to
the valve seat sealing water port, and the valve closes.
Technical data:
| Characteristic | 1)Direct acting,0 rated bar pressure.low power 2)compact design to save the space |
| Medium | Air,water,steam,oil,etc. |
| Temperature | NBR: -10°C to 80 °C EPDM: -10°C to 120 °C FKM:-10°C to 150 °C |
| Pressure | 0-1.6Mpa |
| Port Size | 1/4'' |
| Port Thread | G, NPT |
| Orifice | 2.5mm |
| Voltage | DC-12V,24V AC-24V,120V,110V,220V/50HZ |
| Voltage Range | ±10% |
| Material | Body-Nylon,PP,POM Amature tube-stainless steel 304 Plunger-stainless steel430F Stop-stainless steel 430F Springs-SS304 Shading rings- stainless steel 304 |
Main Dimension of RO Solenoid Water Valve:
Brando Factory Production of Solenoid Valves:
More Plastic Reverse Osmosis Solenoid Valve(RO SV):
Reverse Osmosis systems
A simple reverse osmosis system consists of a high-pressure pump which increases the pressure of the feed water with salts, ions or impurities. This forces the water across the semi permeable RO (Reverse Osmosis) membrane, leaving behind all the dissolved salts. The required pressure is directly proportional to the salt concentration of the inlet water. The higher the concentration, the higher pressure is required to overcome the osmotic pressure.
The RO membrane lets the cleaner water through and this is called permeate water. The salts and other contaminants which are stopped by the membrane come out as a reject stream. This can be drained out or recycled if possible through the RO system to save water.
The RO systems remove up to 99% of dissolved salts (ions), particles, pathogens and bacteria from feed water.
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!
