K0305 24V DC Solenoid Coil For Goyen Type CA Series Electromagnetic Solenoid Pulse Valve

K0305 24V DC Solenoid Coil For Goyen type CA Series Electromagnetic Solenoid Pulse Valve

When the solenoid is energized, a magnetic field is formed. The direction of the magnetic field lines can be determined by the right hand spiral rule. The energized solenoid acts like a strip magnet and has the ability to attract ferromagnetic materials. If the ferromagnetic material is placed in a solenoid, a greater electromagnetic attraction can be produced.The total number of magnetic lines passing through the face is called flux.

The wire diameter of the coil and the magnetic area of the magnetic steel directly affect the magnetic force of the solenoid valve coil, the dc coil can be removed from the core and move freely. The ac solenoid valve coil can not be pulled out from the iron core, once pulled out, will cause a surge in the coil current, seriously burned the coil.

We also have 200/240v 220V AC 50/60Hz(K0300), 100/120V 110V AC 50/60Hz(K0301), 24V AC 50/60Hz(K0302), 110V DC (K0303), 48VDC(K0304), 24V DC(K0305), 12VDC (K0306).
Hole Size: 12mm
Height: 41mm
Width: 37.5mm
Voltage: 24V DC
Power: 20Watt
Connector: DIN43650A
Insulation Class: F.H
Protection Class: IP64
Application: Goyen Type Dust Collector Pulse Valve

Dimension of K0302 24V AC Dust Collector Valve Coil:

Solenoid Pulse Valve Coil Technical Data:

Application Example:

It can be used in all series Goyen type dust collector solenoid valve:

MM Series electro-magnetic pulse valves are embedded valves (also called submerged ones) which are directly installed on the manifold box. They have better flow characteristics and operate with reduced pressure loss, therefore, they are suitable for conditions where the pressure of the gas source is relatively low.

T Series electro-magnetic pulse valves is a right-angle valve, with the 90 degree angle between the inlet and outlet, which is suitable for the installation connection between the gas dome and the baghouse blow tube to provide good air flow and dust clean pulses satisfying the requirements.

DD Series (with 2nuts) electro-magnetic pulse valves are the right-angle valve same as Z type which is suitable for the installation connection between the gas dome and the baghouse blow tube. There are fixed nut at both ends which make it easy to install and use the valve.

FS Series High performance diaphragm valve with flanged inlet and sliding seal outlet for easy installation and removal. Available with integral pilot or remote control valve. The exit and entrance are at a 90 degree angle.

Product Characteristic:
1. Using high quality wire which has UL approved;
2. Using high quality permeablity magnetic material which contain low carbon;
3. Using high quality housing material like PA66, PBT, PPS, BMC and so on.
4. Insulation class can be B, F, H, N, C;
5. Protection class can be IP65, IP67 & IP69K;
6. We also offer special coils like ex-proof coils, water proof coils and so on.
7. If you have special requirement, pls feel free to contact us.

Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing

Welcome to your any question and inquiry!