|
[China]
Trade Verify
Address: 608, Building B, Yinyi Duhui Guoji, No.8, Lane 559, Youngor Avenue, Haishu District, Ningbo, China
Contact name:Brandon Bao
Ningbo Brando Hardware Co., Ltd |
|
Verified Suppliers
|
|
|
4V310-10 3/8'' NPT Airtac Type Electric Control Solenoid Valve 5/2 Way Internal Pilot AC220V DC24V
Characteristics of Brando 4V Series Solenoid Valves:
1. Service life: About 10 million cycle times.
2. The bodies are mirror finished and hardending treated.
3. Equipped with imported oil seals with smaller friction and
longer service life.
4. Copper enameled wire solenoid coils, low power consumption,
speedy response.
5. Capable of long service time without being damaged.
6. For remote electric control fluid conduit in the valve opening
and closing.
7. With solenoid operated for control appropriate flow and
direction, provide great performance.
8. Please note that the gas flow direction and the takeover tooth
type is correct installation.
YouTube video of 4V310-10 3/8'' Airtac Type Pneumatic Solenoid Valve:
Main dimension of 4V310-10 G3/8'' 5/2 Way AirTAC Type Solenoid Valve:
Part details of 4V310-10 Internal Piloted Air Control Solenoid Valve:
Specifications of 4V300 Series AirTAC Type Solenoid Air Valves:
Factory Production of 4V Seires Airtac Type Air Solenoid Valves:
Function of 4V310-08 AirTAC type Directional Control Valve:
This is a 5 Way 2 Position Directional Control Valve used to move
cylinders or actuators. Supply pressure must be supplied to the
center port on the side of the valve with the 3 ports. The outlet
ports on the opposite side are connected to each side of a cylinder
or actuator. The pressure will hold the cylinder in one position
while the other side of the cylinder is exhausted. When voltage is
applied to the solenoid end of the valve, the valve spool will
shift causing air to go to the opposite side of the cylinder while
exhausting the side that was pressurized. This causes the cylinder
to shift (or extend). When the voltage is removed, a spring with an
air assist will return the spool causing the cylinder to return to
it's "at rest" position. Mufflers may be added to the exhaust ports
to quiet the air exhausting. Adjustable Exhaust restrictors may be
used to in the exhaust ports to control the speed of the cylinder.
If flow controls are used, they should always be placed in the
lines between the cylinder and the outlet ports and control the air
flow as it exhausts from the cylinder. This valve may be used to
replace a 4V310-10.
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!
