Hebei Zexu Pipe Manufacturing Co., Ltd. |
|
Zexu specializes in the supply of aluminum target plates for boiler pipe steam purging and targeting
Installation of target board:
The target board is used to place the target board. Pay attention
to the structure and technology of the target board, and have
enough strength. Its structure should be simple, good sealing,
flexible operation, and the exchange of the target board should be
safe and convenient.
Commonly used target plate device structures are flange type,
straight shaft type, tandem shaft type and frame type. The first
three are internal test target plates, and the frame type is
external test target plates.
The target plate of the internal test target plate is installed in
the purge link pipe or exhaust pipe, as close as possible to the
end of the purge pipe, and on the straight pipe 4~6m away from the
elbow.
When the two-stage purging method is adopted, after the first-stage
purging is qualified, the target plate should be removed for the
second-stage purging. It is not advisable to install the target
board at the second-stage purging.
In order to inspect the blowpipe correctly, the target plate should
be polished without visible markings.
After the installation of all equipment in thermal power plants, it
is generally necessary to blow pipes through the boiler to purge
the pipes with steam. The purpose is to remove the debris left in
the equipment and pipes during the manufacturing, transportation
and installation of the equipment and pipes, and to prevent the
boiler from overheating during operation The blower and reheater
block and break the pipe, and at the same time prevent debris from
entering the steam turbine to cause damage to the blades and
valves. Therefore, the boiler and the steam turbine need to be
tested for trial operation before the safe operation of the boiler
and the steam turbine. Therefore, the target plate device used as
the carrier for the blow pipe result inspection is also called the
target plate device. More valued equipment.
The working principle of the target board:
The target plate device is a device used to fix the target plate.
The target plate is a metal plate that is manufactured according to
the material and size and is used to inspect the torch.
The target plate is installed in the temporary exhaust pipe (or at
the exhaust port) at the end of the pipe to be purged. The material
of the target plate can be made of aluminum plate. Its width is
about 8% of the inner diameter of the exhaust pipe and the length
runs through the pipe. For the inner diameter, under the premise of
ensuring the blowpipe coefficient, the target board should be
replaced twice for inspection. The particle size of the impact spot
on the target board is not more than 0.8mm, and the visible spot is
not more than 8 points, and the purging is considered qualified.
Target board material:
The material of the internal target of the target board is aluminum
plate, and the material of the outer shell is 12Cr1MoV. Other
materials can be determined according to customer requirements.
Target board specification parameters:
According to the specifications and dimensions provided by the
customer, the target board interface (flange connection or
flangeless connection)