Active Member
|
[China]
Address: No. 28 Datong Road, Xuguan Town, Suzhou New District, P. R. China, Suzhou, Jiangsu, China
Contact name:Kaisa
Bohyar Engineering Material Technology(Suzhou)Co., Ltd |
|
|
Trav-L-Cutter, or "Travel Cutter," is a portable pipeline cutting, beveling and milling machine with 6in-72in capacity. This machine features atmospheric anti-corrosion package with stainless steel components and special finishes.
The Model TC0672 utilizes a powerful, sealed closed loop hydraulic drive system, includes anti-corrosion package with stainless steel components and special finishes. It is ideally suited for hostile environments or for use underwater.
It is widely used in long distance transport pipeline, power plant, nuclear power, petroleum, chemical engineering, natural gas, boiler shop, pharmacy, pipe prefabrication plant, pipeline installation engineering, rush-repair work, etc.
■ Perfect cold cutting
It has been used in a wide range of applications, including natural gas, crude oil and radioactive environments
■ Compact & portable design
Light weight, only 10"-12"gap, less than 10 minutes to install
■ A wide range of applications
Operate in the trenches full of silt and 25 meters underwater and available for cutting and beveling in flooded trenches and underwater mud at 600 feet.
■ Good stability
Strong corrosion resistance and durable structure
Tools
Model | TC0672 | Processing Range | 6"-72"(153mm-1829mm) |
Drive | Hydraulic | Wall Thickness | 5mm-25mm |
Hydraulic Requirements | 15 gpm @ 1500 psi. | Clearance | 254-305 mm (10"-12") radial, depending on pipe diameter. 20"axial(508 mm) |
Feed Method | Positive, non-slip chain drive. | Finish | Paint |
Cutter Speed | Adjustable 0-60RPM | Installation | Vertical or horizontal installation |
Operating Dimension | 610x510x280(mm) | Operating Weight | 100kg |
Hydraulic Control | Cutter on-off, feed on-off. Flow control valves which can adjust feed speed. Separate controls, providing adjustable feed and cutter speed. Forward/Reverse travel permits machine to be backed up. | ||
■ We have standard beveling tools of 30°, 37° and also can customize the tools.
■ Make sure the work pieces are supported adequately for installation of the equipment. This includes supporting any of the work pieces “fall-off” section when serving the work piece. Ensuring support of the work piece is the responsibility of the operator.
■ Tools on any cutting equipment including drills, milling tools, etc.-may get very hot. Do not touch the tools until you have made sure it is not too hot to handle.
■ Before performing any service on the equipment, disconnect the power source. Follow all procedures required at the worksite.
Warranty Information: The climbing cutting and beveling machine (Travel Cutter) produced by Bohyar has a warranty period of one year. In case of any quality problem during the warranty period, we will provide free maintenance and repairment service.
Trav l Cutter
