Hot Melt Tape PE Pipe Heat Shrinkable Sleeve

1. HSSC-1 Heat shrinkable sleeve (2 layers), which are developed and manufacture by Qingdao Huashida machinery Co., Ltd for anti-corrosion of pipeline, are the composition of radiation cross-linked polyethylene backing and high shearing strengthen melt adhesive, and have the function of shape memory. The hot melt adhesive is squeezed into the joint by the shrink power to form a perfectly sealed surface, after being heated. HSSC-1 is compatible with standard pipe coating, also can be used for coating bare, replacement pipe section and large radius bends. The system is designed to be applied with minimum preheating and is ideal for large diameter wastewater pipe

Application scope
The heat shrinkable sleeve is designed to be applied with minimum preheating and is ideal for large diameter wastewater pipe. 3PE pipe and pre-insulated pipeline joint closure.

Feature
1.Fast shrinkage speed,
2.good waterproof performance,
3 good anti-corrosive performance,
4.long service life, convenient transportation and fast construction.


 

2. 3Layer Fiber

reinforced PE heat shrinkable tape (sleeve) is composed of cross-linked polyethylene back, a middle layer of fiber and special heat melt adhesive an. The 3 layer reinforced sleeve gives better shrink ratio, and better strength. It is resistant to corrosion, wear, impact, UV and aging, easier to be operated.
Application area:
It is mainly used for Hollow wall spiral pipe, corrugated pipe and metal reinforced corrugated spiral pipe etc.

TEST PROCEDURE
1. Clean the steel pipe and heat it by fire till over 80 ºC
2. Paint the steel pipe with Primer (mixed with A&B)
3. Fire heat the heat shrink sleeve, be attention to start heating from middle of the sleeve, but act from up and down, and gradually move from middle to two sides of sleeve, in order to drive air out of the sleeve, after finish heating, the good result is that there is about 1-2mm hot adhesive melt at the edge of sleeve.

Heat shrinkable Sleeve construction

The first is - high mechanical strength, strong anti-aging ability;
Second, good resistance to environmental stress;
Third, excellent bonding performance;
The fourth is - easy to use;
The fifth is the implementation of standards SY/T 23257-2017, NACE RP0303-2003;
Sixth, the application of external anti-corrosion coating :PE, FBE, PP, recommended rust removal grade :Sa 2.5;
The seventh is more prominent - the product specifications can be used for all steel pipes DN100-DN3000;
The eighth is that the thickness of the substrate is from 1.0-2.0mm, and the thickness of the rubber layer is from 0.2-2.5 for various construction models can be selected.

Huashida 3PE special heat shrink belt construction is simple and convenient, anti-corrosion effect is remarkable, in the heating installation, the base material in the radial shrinkage at the same time, the internal composite adhesive layer melts, the adhesive layer will be tightly covered in the repair, together with the base material outside the pipeline to form a solid anti-corrosion body, with excellent wear resistance, corrosion resistance, impact resistance and good UV and light aging resistance. The strength of the glue on the primer steel is greater than 70N, whether it is wound elbow or straight pipe connection, the surface is smooth after baking, no discount, and the bonding strength can reach the national standard.

Huashida Machinery, with over 20 years' experience, is one of the professional oil gas 3pe pipeline girth welding coating heat shrink sleeve manufacturers in China. Offering the customized service, we warmly welcome you to get the high qualified products from our factory.
Looking forward to cooperating with you.