|
[China]
Trade Verify
Address: Room 1018, Floor 10, Building A, Xinghe Century Building, Caitian South Road, Futian District, Shenzhen
Contact name:Xu
ShenzhenYijiajie Electronic Co., Ltd. |
|
Verified Suppliers
|
|
|
SHT75 Pin Type Temperature And Humidity Sensor Chip
The sht7x can be soldered using standard wave soldering. 20 seconds
at a maximum temperature of 235°C. If manual soldering is used, the
contact time should not exceed 5
seconds, the maximum temperature is 350°C. Note: After wave
soldering, store the sensor at >75%rh for at least 12 hours to
ensure that the polymer
of rehydration. Failure to do so will result in drift in sensor
readings. The sensor can also be placed in a natural environment
(humidity>40%rh) for more than 5 days
to rehydrate. In either case, whether manual soldering or reflow
soldering, it is not permissible to rinse the board after
soldering.
Datasheet:
| Model | SHT75 |
| Type | Humidity |
| Material | Mixture |
| Physical properties of the material | Semiconductor |
| Output signal | Digital |
| Sensitivity | ±1% |
