Guangzhou Tianyuan Silicone Machine Technology Co., Ltd. |
|
Liquid silica gel mold is a kind of thermosetting plastic mold. Liquid silica gel can be used as the molding material. It can be sent to the silica gel injection machine through a special mixing system, and injected into the heated liquid silica gel mold by the injection machine at a certain pressure and speed. The desired silica gel product can be obtained.
Hot runner mold, also known as runner free mold, is a mold that uses a heating device to keep the melt in the runner from solidifying
Injection Unit | |||||
Shot Volume | 165g (can be adjusted) | ||||
Injection Rate | 30 g/s | ||||
Injection Pressure | 700kg/cm³ | ||||
Clamping Unit | |||||
Clamping Force | 130 T | ||||
Opening Stroke | 250-550mm | ||||
Tie-Bars Pace | 500*580 | ||||
Ejection Force | 4.3 T | ||||
Ejection Stroke | 150 mm | ||||
Others | |||||
Motor Power | 12.1 KW | ||||
Pump Pressure | 21 Mpa | ||||
Machine Weight | 5.3 T | ||||
Machine Dimension | 2.4*1.6*3.4 M |
The nozzle of cold runner mould is thin and cooled by water
circulation. The runner plate should be used in production, which
is more expensive than that of hot runner. However, the cold runner
die can reduce the generation of waste materials, save raw
materials, and reduce the cost of production; while the hot runner
die is relatively simple in design, low in production cost, and
produces a lot of waste materials in the production process, most
of which are used to produce large products
TYM company