10 Zones Lead Free Reflow Soldering Machine PLC 600mm Zone For SMT SMD

SMT Production Line Machine, Lead Free Reflow Oven 10 Zones Reflow Oven

Lead Free Reflow Oven Equipment With 10 Zones for SMT SMD Production Line

Product Detail of Reflow Oven 10 Zones
1.The digital control system adopted with PLC+Modular Circuit to stabilized and accurate of repetitive precision.
2.Temperature monitoring system to check each zone temp. every second, and auto cut off the power of heater when it over setting temperature .
3. Flat rails with special treatment can ensure no deforming
4. Automatic lubrication system
5. Unique Mirco-circulation Heating Module to make the heat transferring more uniform and efficient
6. Excellent soldering profiles can deal with various lead free process
7. Module design heating system
8. High quality blower motors provides good heat transferring.

Other information of 10 Heating Zones Reflow Oven Equipment 
Center Support :No mesh available if choosing center support.
Dual Lane : Front and rear rails are fixed, center rails are adjustable.
Nitrogen Ready : Including Nitrogen piping, hemertic configuration and N2 flow meter.
Nitrogen system : just add oxygen analyzer and water chiller against above N2 ready.
Nozzle Plate : Micro-circulation hot air.

Parameter Table of Reflow Oven RF-H1010I 10 Zones

Control System

Conveyor Rail

Picture Displaying of 10 Zones Reflow Oven

RFQ About RF-1010I Reflow Oven SMT Machine

How are can make maintenance for reflow oven?

Clear up the flux inside of heating zones and cooling zone (Clean the air holes plate in each zone, there are many flux dross and volatile matter stick on the plate, its possible block the holes).

Take out the filters inside of the flux collect system, and clear up the flux dross on the filters;

Replace the aluminum foil tube on the exhaust hole of the oven, if there is too much flux dross inside;

Inspect the tension of the mesh belt and conveyor chain, adjust the tension of the chain, and if the mesh belt too loose, please remove some sections of the mesh, and reconnect the mesh belt, to get suitable tension;

Add the high temperature lubrication oil in the oil cup, and check if the oil cup work normally;

Clean the transmission mechanism inside of the oven, including gears, screw rods, other mechanical parts, and then brush the high temperature lubrication grease on these parts;

Inspect the electrical cabinet, check every component in cabinet, check the indicator lamp, and then tighten the screws on every terminal by screw driver, especially main circuit, to avoid short circuit.