|
[China]
Trade Verify
Address: Zone C No. 2, Wandong Intelligent Manufacturing Industrial Park, 999 Wentao Road, Ruian Economic Development Zone, Ruian City.Zhejiang.China
Contact name:Cai
Zhejiang Canaan Kaixinlong Technology Co., Ltd. |
|
Verified Suppliers
|
|
|
Overview of the machine:
Capsule Filling Machine For Pharmaceutical Factory Capsule Factory Medical Capsule Filling Machine Industrial
Technical parameters:
| Output | 1500Capsules/min |
| No.of segment bores | 11 |
| Suitable fof capsule | 00#-5# |
| Total power | 8Kw(Standard configuration) |
| Overall weight | 1400Kgs |
| Overall diemensions | 1230mm×1175(+382)mm×1955mm |
| Noise | ≤75DB(A) |
| Pressure | 0.4 ~ 0.7Mpa |
| Air consumption | ≤6m³ |
| Vacuum | -0.03 ~ -0.06Mpa |
| Filling error | ±2.5%~±5% |
The machine may make technical improvements without prior notice, and the attached picture shows the options that may be offered.
Easy to remove the hopper:
 | The old hopper, loosen the hand wheel on the supporting column when disassembly and cleaning, and stretch on the long pressure spring in the column. Most of the hopper must be extended out of the upper Plexiglass to be removed. During the installation, the pressure spring needs to be squeezed to the bottom before tightening the hand wheel, and the employees need to spend a lot of effort to operate. |
 | A screw was added to the supporting post, the screw passed through the panel, the top connecting the hopper support, and the motor and turbine box were installed at the bottom. During hopper disassembly and installation, the whole lifting process can be operated on the PLC operation panel. Due to the use of a single screw support, the work when there is a slight shaking phenomenon. |
 | The split structure is directly fixed on the lower plane of the roof, with simple structure, stable and reliable when working, and convenient hopper disassembly. Release the fast interface of the material cylinder, then loosen the four screws on the hopper, then rotate out the small pin on the paddle, you can horizontally pan out of the filling part. |
Copper collar:
 | 1.Hard column: stable particle weight, loading amount close to the
maximum value, one or two groups of filling rods have obvious
beating, the adjustment range is too small, the machine load is
large, the corresponding parts wear fast. 2.Soft column: stable grain weight, large adjustment range, small
load, small wear of parts. Half column: sometimes appear puff powder particle weight and
light. 3.Scattered sand: leakage, dirty machine table, installation
difference. The gap type copper ring can be replaced with the
sealing type. |
 | According to the material situation, the company provides the optional replacement copper ring |
