The machine may make technical improvements without prior notice,
and the attached picture shows the options that may be offered.
Orientation of the empty capsule:
Broadcast description
The capsule head always acts in the middle of the capsule body, and
the capsule head pushes the capsule to make a U-turn movement,
which always pushes the capsule body to the edge of the capsule
comb, and then presses the capsule head down to turn the capsule
over and push it vertically into the module hole.
principle
1. The thrust point of the capsule head is on the capsule body;
2. The width of the chute is smaller than the outer diameter of the
capsule cap, which is larger than the outer diameter of the capsule
body. It only has a tightness effect on the capsule cap and does
not contact with the capsule body.
Orientation of the empty capsule
Filling-type metering filling:
A-f represents the punching rod of each group, during the interval
after the interval time the angle. The powder in the measuring
plate mold hole is compacted by each group punching rod once. When
the charging rod is lifted from the die hole, the powder box
rotates, and the powder on the metering plate will automatically
fill the remaining space in the die hole. Fill once, compaction
once, until the sixth time, the punching rod will poke the powder
column in the mold hole out of the measuring plate, so that it will
fall into the empty capsule below, complete the filling work.
Use the relative movement between the scraping powder block and the
measuring plate to scrape the excess powder on the surface of the
measuring plate to ensure the measurement requirements of the
powder column.
The characteristics of the packing-type measurement method
1. The loading amount is accurate, and the difference of the
loading amount of> 0.3g is controlled within ± 3%.
2. Adjust the lifting height of the punching rod to fine-tune the
dose of drug filling.